Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markCharacter Sets Swap Remove

A new character set must be able to represent 70 different characters.

Identify the minimum number of bits needed to represent each character.

[1 mark]
  • A6
  • B7
  • C8
  • D70
Mark scheme
  • B 7 (1)
  • The only correct answer is B. The correct answer is 7.
  • A is not correct because 6 bits give only 64 combinations, which is not enough for 70 characters
  • C is not correct because 7 bits already give 128 combinations, so 8 bits is not the minimum needed
  • D is not correct because 70 is the number of characters needed, not a number of bits
Example answers and how they were marked
Full marks1/1

B 7

Why: The only correct answer: 7 bits give 128 combinations, enough for 70 characters, and it is the smallest number of bits that does (1).

No marks0/1

C 8

Why: Distractor, no credit: a single-tick item has no partial credit, and 8 bits is not the minimum because 7 bits already give 128 combinations, so the scheme's C line gives no mark.

No marks0/1

A 6

Why: Misconception, no credit: 6 bits give only 64 combinations, which cannot represent 70 different characters, so the scheme's A line gives no mark.

2Short recall2 marksStored Program Computers Swap Remove

The central processing unit (CPU) contains an arithmetic logic unit (ALU).

State two types of operation carried out by the ALU.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • An arithmetic operation, e.g. addition/subtraction/multiplication/division (1)
  • A logical operation, e.g. comparing two values (is A > B?) / using AND, OR, NOT (1)

Do not accept decoding instructions, fetching instructions or controlling the timing of the CPU, as these are carried out by the control unit.

Example answers and how they were marked
Full marks2/2

It carries out arithmetic operations such as addition and subtraction, and logical operations such as comparing two values to see if one is greater than the other.

Why: Arithmetic operation (1) and logical operation (1).

Some marks1/2

It adds numbers together and works out the result.

Why: Arithmetic operation, addition (1). No logical operation.

No marks0/2

It decodes the instructions that have been fetched from main memory.

Why: Decoding and fetching are the control unit's role; the mark scheme's do-not-accept line covers this.

3Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

4Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.