Edexcel GCSE Computer Science (1CP2) Exam Questions

• C 128 (1)
• The only correct answer is C. The correct answer is 128.
• A is not correct because 6 bits give only 64 different combinations
• B is not correct because 127 is the largest 7-bit value, not the number of characters that 7 bits can represent
• D is not correct because 256 characters need 8 bits, as used by 8-bit extended ASCII

Award one mark for any of the following up to a maximum of two marks:

• An arithmetic operation, e.g. addition/subtraction/multiplication/division (1)
• A logical operation, e.g. comparing two values (is A > B?) / using AND, OR, NOT (1)

Do not accept decoding instructions, fetching instructions or controlling the timing of the CPU, as these are carried out by the control unit.

Award up to two marks for a linked description such as:

• Parts of a file are moved so they are stored together/in consecutive locations (1) so the read/write head has less distance to travel to read the file (1)
• Files are rearranged so that each file is stored in one block (1) which reduces the time taken to open/load the file (1)
• Free space on the disk is collected into one area (1) so new files can be saved without becoming fragmented (1)
• The parts of each fragmented file are put in order (1) so fewer movements of the read/write head are needed to read it (1)

Do not accept responses about compressing files, deleting files or increasing the amount of storage, as these are not what defragmentation software does.

Do not accept 'it makes the disk faster' without saying how the files are changed.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Indicative content

How each translator deals with a syntax error

• An interpreter stops as soon as it finds a syntax error and displays an error message.
• With an interpreter, the lines before the error have already been executed, so the student can see how far the program got before it stopped.
• A compiler reports errors at the end of translation, so the student gets a list of all the syntax errors in the program in one go.

How much of the program is translated at a time

• An interpreter translates one line at a time and executes each line immediately.
• A compiler translates the whole program in one go before any of it is run.
• A compiler produces object code, so after every change the whole program must be compiled again before the student can run it.
• An interpreter produces no object code, so the student does not have to wait for the whole program to be translated before it runs.

How this affects the student's testing

• An interpreter suits this student because the program can be run straight away after each small change.
• The interpreter stops at the first error found, so the student fixes that error and runs the program again, but may only find the next error on the next run.
• Reporting every error at the end of compilation means the student can fix several errors at once, but cannot run the program until the whole program compiles.
• The student should use an interpreter while testing, and compile the finished program once it works.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 responses must relate the way each translator works to the student's testing, not just describe the two translators.

Do not accept answers about run-time or logic errors where no comparison of the translators is made.