Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 604 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markCharacter Sets Swap Remove

Characters are encoded using 7-bit ASCII.

Identify the number of different characters that can be represented using 7-bit ASCII.

[1 mark]
  • A64
  • B127
  • C128
  • D256
Mark scheme
  • C 128 (1)
  • The only correct answer is C. The correct answer is 128.
  • A is not correct because 6 bits give only 64 different combinations
  • B is not correct because 127 is the largest 7-bit value, not the number of characters that 7 bits can represent
  • D is not correct because 256 characters need 8 bits, as used by 8-bit extended ASCII
Example answers and how they were marked
Full marks1/1

C 128

Why: Selects the only correct option (1): 7 bits give 2 to the power of 7, which is 128 different characters.

No marks0/1

D 256

Why: Near miss scoring 0: 256 is the number of characters that 8 bits give in extended ASCII, not 7-bit ASCII.

No marks0/1

B 127

Why: Misconception scoring 0, the off-by-one error the examiners' report describes: 127 is the largest 7-bit value, but 7 bits give 128 different characters.

2Short recall2 marksStored Program Computers Swap Remove

The central processing unit (CPU) contains an arithmetic logic unit (ALU).

State two types of operation carried out by the ALU.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • An arithmetic operation, e.g. addition/subtraction/multiplication/division (1)
  • A logical operation, e.g. comparing two values (is A > B?) / using AND, OR, NOT (1)

Do not accept decoding instructions, fetching instructions or controlling the timing of the CPU, as these are carried out by the control unit.

Example answers and how they were marked
Full marks2/2

It carries out arithmetic operations such as addition and subtraction, and logical operations such as comparing two values to see if one is greater than the other.

Why: Arithmetic operation (1) and logical operation (1).

Some marks1/2

It adds numbers together and works out the result.

Why: Arithmetic operation, addition (1). No logical operation.

No marks0/2

It decodes the instructions that have been fetched from main memory.

Why: Decoding and fetching are the control unit's role; the mark scheme's do-not-accept line covers this.

3Describe2 marksMemory Management Swap Remove

The operating system is held in main memory while the computer is running.

Describe how the operating system stops a running program from overwriting memory that is not its own.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • It keeps a record of which memory addresses/areas belong to each program and to the operating system (1) so it knows which addresses a program is allowed to use (1)
  • Each program is given its own area of main memory (1) so a program cannot write to the addresses used by another program or by the operating system (1)
  • The memory used by the operating system is marked as protected/reserved (1) so a program that tries to write to it is blocked/causes an error (1)
  • The address a program writes to is checked against the record of its allocated area (1) and the write is stopped if the address is outside that area (1)

Allow the memory being protected to be that of the operating system or of another program.

For both marks, the expansion must follow/associate with the statement.

Do not award generic answers such as 'the operating system manages memory' or 'the operating system keeps track of memory'.

Do not award responses about stopping programs using too much memory or allocating memory, as these are not about protecting memory being overwritten.

Do not award responses about virtual memory, paging or moving processes to secondary storage.

Do not award responses about firewalls, antivirus software or passwords.

Example answers and how they were marked
Full marks2/2

The operating system gives each program its own area of main memory so that a program cannot write to the addresses used by another program or by the operating system.

Why: Each program is given its own area of main memory (1) linked to it not being able to write to the addresses used by another program or the operating system (1).

Some marks1/2

The operating system gives each program its own area of main memory.

Why: Each program is given its own area of main memory (1), but there is no linked development saying how this stops a program overwriting memory that is not its own.

No marks0/2

The operating system stops a program overwriting memory by moving it into virtual memory when it uses too much.

Why: This describes virtual memory and limiting how much memory a program uses, not protecting memory from being overwritten, so neither bullet applies and the Do not award lines rule it out.

4Explain2 marksProtocols & Layers Swap Remove

Two computers exchange data over a network.

Explain why network protocols are needed for the two computers to communicate.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Devices (can) understand/interpret the data they receive (1) because they follow the same set of rules for communication (1)
  • Data is sent in an agreed format/structure (1) so the receiving device can interpret/understand it correctly (1)
  • Devices (can) connect/communicate successfully (1) because they agree how the data is transmitted, such as the type of signal used (1)
  • Errors (can) be detected/handled (1) because both devices follow the same rules for checking the data (1)

For both marks, the expansion must follow/associate with the statement.

Do not accept 'so devices can talk/communicate with each other' or 'so they can understand each other' without saying they follow the same rules/agreed format.

Do not accept an answer that only states protocols are a set of rules, without saying what this allows (e.g. the data can be understood/interpreted).

Do not accept a faster connection/speed as a reason why protocols are needed.

Do not accept naming a protocol (e.g. TCP/IP, HTTP, Wi-Fi) without an explanation of why it is needed.

Do not accept a description of what a protocol does (e.g. 'TCP splits data into packets') without saying why this is needed.

Example answers and how they were marked
Full marks2/2

Devices can understand the data they receive (1) because they follow the same set of rules for communication (1).

Why: Linked point (1) and reason (1): following the same rules is what lets the devices understand the data.

Some marks1/2

Data is sent in an agreed format (1).

Why: Point (1) identified, but no linked reason saying what the agreed format achieves.

No marks0/2

Protocols are needed so the connection is faster (0) because more data can be sent at once.

Why: Speed is not a reason protocols are needed, so there is no creditworthy point or linked reason.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 18
Data Protection Act 14 questions Impact of AI 4 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.