Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 573 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 9 marks

Pick again
Print
1Multiple choice1 markCharacter Sets Swap Remove

Characters are encoded using 7-bit ASCII.

Identify the number of different characters that can be represented using 7-bit ASCII.

[1 mark]
  • A64
  • B127
  • C128
  • D256
Mark scheme
  • C 128 (1)
  • The only correct answer is C. The correct answer is 128.
  • A is not correct because 6 bits give only 64 different combinations
  • B is not correct because 127 is the largest 7-bit value, not the number of characters that 7 bits can represent
  • D is not correct because 256 characters need 8 bits, as used by 8-bit extended ASCII
Example answers and how they were marked
Full marks1/1

C 128

Why: Selects the only correct option (1): 7 bits give 2 to the power of 7, which is 128 different characters.

No marks0/1

D 256

Why: Near miss scoring 0: 256 is the number of characters that 8 bits give in extended ASCII, not 7-bit ASCII.

No marks0/1

B 127

Why: Misconception scoring 0, the off-by-one error the examiners' report describes: 127 is the largest 7-bit value, but 7 bits give 128 different characters.

2Short recall2 marksStored Program Computers Swap Remove

The central processing unit (CPU) contains an arithmetic logic unit (ALU).

State two types of operation carried out by the ALU.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • An arithmetic operation, e.g. addition/subtraction/multiplication/division (1)
  • A logical operation, e.g. comparing two values (is A > B?) / using AND, OR, NOT (1)

Do not accept decoding instructions, fetching instructions or controlling the timing of the CPU, as these are carried out by the control unit.

Example answers and how they were marked
Full marks2/2

It carries out arithmetic operations such as addition and subtraction, and logical operations such as comparing two values to see if one is greater than the other.

Why: Arithmetic operation (1) and logical operation (1).

Some marks1/2

It adds numbers together and works out the result.

Why: Arithmetic operation, addition (1). No logical operation.

No marks0/2

It decodes the instructions that have been fetched from main memory.

Why: Decoding and fetching are the control unit's role; the mark scheme's do-not-accept line covers this.

3Short recall2 marksUnits & Conversion Swap Remove

A solid state drive has a capacity of 5 gibibytes.

Give an expression to calculate the number of bits in 5 gibibytes. You do not need to do the calculation.

[2 marks]
Mark scheme

Award one mark for each of:

  • 5 × 1024^3 / 5 × 1024 × 1024 × 1024 / 5 × 2^30, for the number of bytes (1)
  • A fully correct expression with × 8 to convert bytes to bits, in any order, e.g. 5 × 1024^3 × 8, 8 × 5 × 2^30 (1)

Accept 5 × 1 073 741 824 × 8.

Accept 5 × 2^33 or 42 949 672 960 as a fully correct expression (2 marks).

Do not accept 5 × 1000^3 × 8, which uses decimal multiples.

Do not accept ÷ 8, which converts bits to bytes.

Example answers and how they were marked
Full marks2/2

8 × 5 × 2^30

Why: 5 × 2^30 is the number of bytes (1) and × 8 converts bytes to bits (1).

Some marks1/2

5 × 2^30

Why: Correct number of bytes using the binary multiple 2^30 (1), but no conversion to bits.

No marks0/2

5 × 1000^3 × 8

Why: Uses decimal 1000^3 instead of binary 1024^3, so the expression is not fully correct; no creditworthy point.

4Describe2 marksLow and High Level Languages Swap Remove

A device driver is software that allows the operating system to control a piece of hardware. Device drivers are often written in a low-level programming language.

Describe one reason why a low-level programming language is suitable for writing a device driver.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
  • The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
  • The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
  • Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Example answers and how they were marked
Full marks2/2

Low-level instructions can manipulate the hardware and memory directly (1) so the driver can control the specific device it was written for, such as a sound card (1).

Why: Point about direct control of hardware/memory (1) linked to controlling the specific device (1). The named device is extra detail and is not needed.

Some marks1/2

Low-level instructions can manipulate the hardware directly.

Why: Correct point (1) but no linked development saying how this helps the device driver.

No marks0/2

It is closer to machine code so it runs faster than a high-level language.

Why: 'Closer to machine code' is not developed into how this helps the driver, and 'runs faster' is not linked to the hardware/device, so no mark.

5Calculate2 marksBinary Shifts Swap Remove

Computers manipulate binary patterns.

Complete the table with the result of applying the shift to the binary pattern.

[2 marks]
Binary patternShift8-bit binary result
1000 0001Logical shift right by 1
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 0100 (1)
  • 0000 (1)

0 marks if the response is not 8-bit binary.

Example answers and how they were marked
Full marks2/2

0100 0000

Why: Every bit moves 1 place right, with 0s in from the left: both nibbles are correct (2).

Some marks1/2

0100 0001

Why: A slip in the last bit. The first nibble is correct (1); the second is not.

No marks0/2

0000 0010

Why: Shifts the bits the wrong way. Neither nibble is correct.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 23
E-waste 15 questions Manufacturing Technology 8 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.