Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

2 questions · 3 marks

Pick again
Print
1Multiple choice1 markCharacter Sets Swap Remove

Characters are encoded using 7-bit ASCII.

Identify the number of different characters that can be represented using 7-bit ASCII.

[1 mark]
  • A64
  • B127
  • C128
  • D256
Mark scheme
  • C 128 (1)
  • The only correct answer is C. The correct answer is 128.
  • A is not correct because 6 bits give only 64 different combinations
  • B is not correct because 127 is the largest 7-bit value, not the number of characters that 7 bits can represent
  • D is not correct because 256 characters need 8 bits, as used by 8-bit extended ASCII
Example answers and how they were marked
Full marks1/1

C 128

Why: Selects the only correct option (1): 7 bits give 2 to the power of 7, which is 128 different characters.

No marks0/1

D 256

Why: Near miss scoring 0: 256 is the number of characters that 8 bits give in extended ASCII, not 7-bit ASCII.

No marks0/1

B 127

Why: Misconception scoring 0, the off-by-one error the examiners' report describes: 127 is the largest 7-bit value, but 7 bits give 128 different characters.

2Short recall2 marksSound Swap Remove

A sound wave is sampled and the amplitude of each sample is stored using a small number of bits.

Give two limitations of storing the sound in binary when only a small number of bits is available for each sample.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Only a limited/fixed number of amplitude values can be stored (1)
  • The amplitude of each sample is rounded/approximated to the nearest value that can be stored (1)
  • The recording is less accurate than the original analogue sound/does not match the analogue wave exactly (1)
  • Sounds louder than the highest amplitude that can be stored are clipped/distorted (1)
  • Sounds quieter than the lowest amplitude that can be stored cannot be represented/are lost (1)

Allow quantisation error/noise for the amplitude being rounded to the nearest value that can be stored, but do not award a second mark for the same idea

Allow a stated consequence as a separate mark only when it is a different point from the list, e.g. fewer amplitude values can be stored (1) so very quiet sounds are lost (1)

Do not accept 'lower quality'/'poorer sound' on its own; the answer must say the recording is less accurate than the original/does not match the analogue wave

Do not accept sample rate/sample interval/number of channels (stereo/mono), as these are not limited by the number of bits available for each sample

Do not accept remedies such as 'a larger bit depth would make it more accurate', as these do not describe a limitation

Do not accept answers about file size, compression or playback method

Do not accept a statement that repeats the stem, e.g. 'the sound is stored in binary using a fixed number of bits'

Example answers and how they were marked
Full marks2/2

The amplitude of each sample has to be rounded to the nearest value that can be stored, and very quiet sounds cannot be represented.

Why: Amplitude rounded to the nearest stored value (1) and quiet sounds cannot be represented (1): two different points from the list.

Some marks1/2

The recording is less accurate than the original sound.

Why: The recording is less accurate than the original analogue sound (1); a second, different limitation is not given.

No marks0/2

The sample rate is too low, so parts of the wave are missed.

Why: Sample rate is not limited by the number of bits per sample, so it is not accepted.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.