Edexcel GCSE Computer Science (1CP2) Exam Questions

• B 7 (1)
• The only correct answer is B. The correct answer is 7 bits.
• A is not correct because 6 bits give only 64 different characters
• C is not correct because 8 bits are used by extended ASCII to give 256 characters
• D is not correct because 16 bits give 65 536 different characters, which is far more than the 128 in ASCII

Award one mark for:

• Laser (1)

Allow laser beam

Do not accept read/write head

Do not accept pits

Do not accept lands

Do not accept reflective surface

Do not accept magnet/magnetic

Award one mark for any of the following up to a maximum of two marks:

• A binary digit (1)
• Has the value 0 or 1 (1)
• The smallest unit of data storage (1)
• A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Devices (can) understand/interpret the data they receive (1) because they follow the same set of rules for communication (1)
• Data is sent in an agreed format/structure (1) so the receiving device can interpret/understand it correctly (1)
• Devices (can) connect/communicate successfully (1) because they agree how the data is transmitted, such as the type of signal used (1)
• Errors (can) be detected/handled (1) because both devices follow the same rules for checking the data (1)

For both marks, the expansion must follow/associate with the statement.

Do not accept 'so devices can talk/communicate with each other' or 'so they can understand each other' without saying they follow the same rules/agreed format.

Do not accept an answer that only states protocols are a set of rules, without saying what this allows (e.g. the data can be understood/interpreted).

Do not accept a faster connection/speed as a reason why protocols are needed.

Do not accept naming a protocol (e.g. TCP/IP, HTTP, Wi-Fi) without an explanation of why it is needed.

Do not accept a description of what a protocol does (e.g. 'TCP splits data into packets') without saying why this is needed.

Award one mark for each correct nibble in the correct order:

• 1011 (1)
• 0111 (1)

0 marks if the response is not 8-bit binary.

Ignore a carry shown beyond the eighth bit.

Award one mark for:

• overflow (error) (1)

Indicative content

How each translator deals with a syntax error

• An interpreter stops as soon as it finds a syntax error and displays an error message.
• With an interpreter, the lines before the error have already been executed, so the student can see how far the program got before it stopped.
• A compiler reports errors at the end of translation, so the student gets a list of all the syntax errors in the program in one go.

How much of the program is translated at a time

• An interpreter translates one line at a time and executes each line immediately.
• A compiler translates the whole program in one go before any of it is run.
• A compiler produces object code, so after every change the whole program must be compiled again before the student can run it.
• An interpreter produces no object code, so the student does not have to wait for the whole program to be translated before it runs.

How this affects the student's testing

• An interpreter suits this student because the program can be run straight away after each small change.
• The interpreter stops at the first error found, so the student fixes that error and runs the program again, but may only find the next error on the next run.
• Reporting every error at the end of compilation means the student can fix several errors at once, but cannot run the program until the whole program compiles.
• The student should use an interpreter while testing, and compile the finished program once it works.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 responses must relate the way each translator works to the student's testing, not just describe the two translators.

Do not accept answers about run-time or logic errors where no comparison of the translators is made.