Edexcel GCSE Computer Science (1CP2) Exam Questions

• B 7 (1)
• The only correct answer is B. The correct answer is 7 bits.
• A is not correct because 6 bits give only 64 different characters
• C is not correct because 8 bits are used by extended ASCII to give 256 characters
• D is not correct because 16 bits give 65 536 different characters, which is far more than the 128 in ASCII

Award one mark for any of the following up to a maximum of two marks:

• A binary digit (1)
• Has the value 0 or 1 (1)
• The smallest unit of data storage (1)
• A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Award up to two marks for a linked description such as:

• Attempts to repair/rebuild the corrupted file (1) so that it can be opened by its program again (1)
• Recovers/retrieves the parts of the file that can still be read (1) so that the user does not lose all of the data in the file (1)
• Reconstructs the file from data held in other parts of the disk (1) because part of the file/the disk is corrupted (1)
• Saves a new/repaired copy of the file (1) as some of the data in it may not be recoverable (1)

Do not accept 'it repairs the file' on its own, as this repeats the question.

Do not accept responses about restoring a backup/previous version of the file, as this is backup software.

Do not accept responses about scanning for or removing malware.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Award one mark for each correct nibble in the correct order:

• 0100 (1)
• 0000 (1)

0 marks if the response is not 8-bit binary.