Edexcel GCSE Computer Science (1CP2) Exam Questions

• B 7 (1)
• The only correct answer is B. The correct answer is 7 bits.
• A is not correct because 6 bits give only 64 different characters
• C is not correct because 8 bits are used by extended ASCII to give 256 characters
• D is not correct because 16 bits give 65 536 different characters, which is far more than the 128 in ASCII

Award one mark for any of the following:

• More files/data can be stored (in the same storage space) (1)
• The files take up less storage space (1)
• The backup is quicker/faster to complete (1)
• Less data needs to be transferred to the backup device (1)

Do not accept 'makes the files more secure' or 'encrypts the files'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Indicative content

Control of the hardware

• Low-level languages can read and write the contents of registers and memory addresses directly, so the firmware can take the values from the distance sensors without calling a library routine.
• Assembly language instructions can read from and write to specific input/output ports on the vacuum cleaner's processor, so the motors can be switched on and off directly.
• The programmer decides exactly which processor operations are carried out and in which order, which matters when the vacuum must reverse away from a step or an obstacle.
• A low-level language puts nothing between the program and the hardware, so the programmer can control the hardware of the vacuum cleaner precisely.

Efficiency of the code

• Assembly language code can be hand-optimised instruction by instruction, so the code that checks a sensor is as short as possible.
• The programmer can choose which registers hold values that are used again and again, which cuts down the number of memory accesses the firmware needs.
• A hand-written low-level program can be made compact, so it is more likely to fit in the small amount of memory the vacuum cleaner has.
• Because each instruction does one defined job, the time taken to react to a sensor reading is predictable, which suits firmware that must not overrun.

Link between the language and the processor

• Low-level languages are processor-specific, so the instructions used are those of the exact processor in the vacuum cleaner rather than general statements that need translating.
• Each assembly language instruction maps to one machine code instruction, so the programmer knows precisely which processor operation will be carried out by each line of code.
• An assembler turns each mnemonic into its machine code equivalent, so the machine code running on the vacuum cleaner's processor is exactly what the programmer wrote.
• Code written for a different processor would have to be rewritten, which is acceptable here because the vacuum cleaner always uses the same processor.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Within Level 1, award 1 mark for a single basic point and 2 marks for two or more independent basic points; Level 2 requires the points to be linked to the vacuum cleaner; Level 3 requires both control of the hardware and efficiency of the code, and a few concise, linked sentences can reach Level 3, so extra length is not required.

Accept registers, memory addresses, input/output ports, machine code and mnemonics as ways of describing access to the hardware, and accept 'a low-level language is faster' as a basic point on its own. Do not award 'binary is a low-level language' (machine code is written in binary, but binary is not a language), or characteristics of high-level languages such as being easy to read or portable, as characteristics of a low-level language.