Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 8 marks

Pick again
Print
1Describe2 marksStored Program Computers Swap Remove

The control unit (CU) is a component inside the CPU.

Describe the role of the control unit in the fetch-decode-execute cycle.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Decodes each (fetched) instruction (1) to work out which operation is needed / which components should carry it out (1)
  • Coordinates/directs the other components (1) by sending control signals along the control bus (1)
  • Fetches the next instruction (1) by sending its address to main memory along the address bus (1)
  • Sends a read/write control signal to main memory (1) so that the instruction or data is transferred during the fetch/execute stage (1)

Do not accept answers about synchronising the CPU or timing the cycles (that is the role of the clock).

Do not accept answers about carrying out arithmetic or logical operations (that is the ALU).

Do not accept answers about holding data or the results of instructions (that is registers/main memory).

Do not accept generic answers that only say the CU controls the CPU or processes instructions, with no linked development.

Only award one mark for a response that only repeats that the CU sends control signals; the second mark needs a linked outcome such as coordination, a memory read/write, or fetching an instruction.

Do not accept 'during the decode stage' as the development for the decoding point, as it restates the question.

Example answers and how they were marked
Full marks2/2

It decodes the instruction that has been fetched so that it knows which operation the CPU must carry out and which components should do it.

Why: Decoding named with the acceptable wording 'each (fetched) instruction' (1), plus the linked development that this identifies the operation and components (1).

Some marks1/2

It decodes each instruction during the decode stage of the cycle.

Why: Earns (1) for decoding the instruction. 'During the decode stage' restates the question and is not accepted as a development, so the second mark is not earned.

No marks0/2

It carries out the calculations and comparisons when the instruction is executed.

Why: Calculations and comparisons are the ALU's role, which the 'Do not accept' line rules out, so no mark is earned.

2Describe2 marksSecondary Memory Swap Remove

A laptop uses a solid state drive (SSD) for secondary storage.

Describe how data is stored on a solid state drive.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Data is stored on (flash) memory chips/cells (1) as a pattern of electrical charges (1)
  • A current/voltage forces electrons through a barrier (1) so that they are trapped (or not trapped) to hold/represent a value (1)
  • Cells with a trapped charge and cells with no trapped charge (1) represent 1s and 0s/binary (1)
  • The trapped charge remains when the power is turned off (1) so the data is not lost/it is non-volatile (1)

Do not accept responses that describe magnetic storage, e.g. magnetised platters, spinning disks or read/write heads, or optical storage, e.g. lasers, pits and lands.

Do not award a mark for 'it is solid state' or 'it has no moving parts' without a description of how the data is stored.

Do not award a mark for restating the stem, e.g. 'a laptop uses an SSD' or 'an SSD uses flash memory'.

'Data is stored as electrical charges' on its own, with no reference to memory chips/cells or to how the charge is held, earns a maximum of one mark (1).

A response that only describes electrons being trapped, with no link to how the value/data is represented, earns one mark (1). The second mark needs a link such as trapped and not trapped charge representing 1s and 0s, or the trapped charge being kept so the data is not lost.

Example answers and how they were marked
Full marks2/2

A current is used to force electrons through a barrier so that they become trapped, and a cell with a trapped charge or a cell with no trapped charge represents a 1 or a 0.

Why: Linked description: a current forces electrons through a barrier (1) and trapped/not trapped charge represents 1s and 0s (1).

Some marks1/2

The data is stored in flash memory chips.

Why: Gives the creditworthy point that data is stored on flash memory chips (1) but does not develop it, e.g. by saying the data is held as electrical charges or by describing trapped electrons.

No marks0/2

The data is stored as magnetised areas on a spinning platter.

Why: This describes magnetic storage, which the mark scheme says not to accept for a solid state drive.

3Explain2 marksEmbedded Systems Swap Remove

An engine control unit (ECU) in a car is an embedded system.

Explain one benefit of using an embedded system for the engine control unit instead of a general purpose computer.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • (The ECU) is more reliable/less likely to crash (1) because it only runs the one program/has a single purpose (1)
  • (The ECU) cannot be affected by other software/viruses (1) because it cannot run other software/it can only run the program it was made for (1)
  • (The ECU) is cheaper (1) because it has limited processing resources/less memory/simple components (1)
  • (The ECU) uses less power (1) because it has limited processing resources/a simpler processor (1)
  • (The ECU) is smaller (1) because it has fewer components/less memory than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

A suitable benefit stated on its own earns one mark.

Do not accept a description or a location given as the reason, e.g. 'because it is part of the car', 'because it is inside the engine', 'because it is embedded'.

Do not accept a description of an embedded system on its own as the benefit, e.g. 'it does one specific job' or 'it is part of the car'.

Do not accept 'it is faster'/'it has a more powerful processor' as embedded systems have limited processing resources.

Example answers and how they were marked
Full marks2/2

It is more reliable than a general purpose computer because it only runs the one program so it will not crash and stop the engine working.

Why: Benefit stated (1) with a linked reason (1); the reason shows why only running one program makes it reliable.

Some marks1/2

It is more reliable because it is part of the car's engine.

Why: Only the benefit earns a mark (1); being part of the car is a location, not a linked reason why it is reliable.

No marks0/2

It is faster than a general purpose computer because it is embedded in the engine.

Why: Misconception that an embedded system is faster; embedded systems have limited processing resources, so neither point nor reason is creditworthy.

4Explain2 marksPrimary Memory Swap Remove

A computer follows the von Neumann stored program concept. A program's instructions are stored on secondary storage before the program is run.

Explain one reason why the instructions of a program must be held in RAM before they can be executed.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The CPU can only fetch/read instructions from main memory/RAM (1) so the instructions of a running program must be copied/loaded into RAM before they can be executed (1)
  • RAM is faster to access than secondary storage (1) so the instructions can be fetched quickly enough for the CPU to execute them (1)
  • The CPU needs the instructions in RAM to fetch and execute them (1) because the fetch-decode-execute cycle reads each instruction from main memory/RAM (1)
  • The address of the next instruction is sent to RAM on the address bus (1) so the instruction can be transferred to the CPU/registers for decoding/execution (1)

For both marks, the expansion must follow/associate with the statement.

Allow the point and reason in either order if they are linked.

Do not accept answers that only say the CPU needs instructions, or that RAM is faster, without linking this to fetching/executing the instructions.

Do not accept answers that only say RAM holds data and instructions without linking this to the fetch-decode-execute cycle.

Do not accept 'RAM is permanent/non-volatile storage, so the instructions are kept safe' - RAM is volatile.

The response does not need to name the address bus or the fetch stage for full marks; a linked reason that explains why instructions must be in RAM (for example, the CPU can only fetch from RAM, or RAM is faster than secondary storage) is enough.

Example answers and how they were marked
Full marks2/2

The CPU can only fetch instructions from main memory, so the instructions of a running program must be copied into RAM before they can be executed.

Why: Linked point (1) for the CPU only being able to fetch instructions from main memory/RAM, and reason (1) for instructions being copied into RAM before execution.

Some marks1/2

The CPU can only fetch instructions from main memory.

Why: Point (1) only; there is no linked reason that explains why this means the instructions must be held in RAM before execution, such as RAM being faster than secondary storage.

No marks0/2

Instructions are kept in RAM because RAM is permanent storage and does not lose the instructions when the power is turned off.

Why: Misconception: RAM is described as permanent/non-volatile, which the mark scheme's 'Do not accept' line rules out; no creditworthy linked point.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.