Edexcel GCSE Computer Science (1CP2) Exam Questions

Award up to two marks for a linked description such as:

• The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
• The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
• The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
• The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Indicative content

Why secondary storage is needed

• Secondary storage is non-volatile, so it keeps the operating system, applications and students' work when the power is turned off.
• It stores programs and files that are not currently in use, so they are not lost when the computer is switched off.
• It provides a larger capacity than primary storage for files such as students' work, videos and photographs.
• It allows each computer to keep many students' files and the software the school has installed.

The difference between primary and secondary storage

• Primary storage (RAM) is volatile and directly accessible by the CPU; secondary storage is non-volatile and not directly accessible by the CPU.
• RAM holds the data and instructions currently in use; secondary storage holds data and programs long term.
• Primary storage is faster but smaller and more expensive per gigabyte; secondary storage is slower but larger and cheaper.
• The school's computers need both: RAM to run the operating system and applications, and secondary storage to keep them when the computer is switched off.

A suitable type of secondary storage for the school's computers and a reason why it is suitable

• A solid state drive (SSD) is suitable because it has no moving parts, so it is durable and quiet, and has fast read/write speeds, which helps the computers start up quickly.
• A magnetic hard disk drive (HDD) is suitable because it is cheap and offers a very large capacity, which is useful for storing many students' files.
• Either type could be used; a small SSD for the operating system and applications plus a large HDD for files would balance speed and cost.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Additional guidance

• Award credit for a type of secondary storage only when a reason is given that is linked to the school's computers; a named type alone (e.g. 'SSD') is not creditworthy. Do not accept RAM as secondary storage or the claim that secondary storage is the same as RAM. Do not accept CD/DVD/Blu-ray as the main storage for the school's computers because their capacity is too low and write speeds are slow.
• For Level 3, the answer must cover all three bullets and apply at least one point to the school's computers. A 6-mark answer is well developed with sustained reasoning and a justified choice; a 5-mark answer covers all three but with limited development or application. Comparisons of speed and cost between primary and secondary storage are creditworthy as part of the difference.

Indicative content

Control unit and ALU

• The control unit fetches and decodes each instruction that the new computers are running, so it works out which operation has to be carried out.
• The control unit sends control signals to the ALU and to main memory over the control bus so that the other components carry out the instruction.
• The control unit receives the clock signal, so each stage of the cycle begins on a clock tick.
• The ALU carries out arithmetic operations, such as adding two values, and logical operations, such as comparing two values, during the execute stage.
• The ALU is the component that performs the calculations that a program running on the new computers needs.
• The data the ALU works on is held in registers, and the result of the operation is stored in a register such as the accumulator.

Registers

• Registers are small, very fast memory locations inside the CPU that hold the instructions and data the CPU is working on.
• The program counter holds the address of the next instruction to be fetched, and it is incremented each time an instruction is fetched.
• The memory address register (MAR) holds the address of the main memory location that is to be read from or written to during the fetch stage.
• The memory data register (MDR) holds the instruction or data brought from main memory (RAM) over the data bus before it is decoded.
• The accumulator holds the result of an operation carried out by the ALU.
• Because registers are inside the CPU, the CPU can keep working on a value without going back to slower main memory during the cycle.

Working together as the cycle repeats

• In the fetch stage, the address of the next instruction is copied from the program counter into the memory address register and sent to main memory over the address bus, and the instruction comes back over the data bus into the memory data register.
• In the decode stage the control unit interprets the instruction and works out which components are needed for it.
• In the execute stage the control unit signals the ALU or main memory so that the instruction is carried out, and the result is held in a register.
• The clock sends a regular pulse so that the fetch, decode and execute stages of each instruction happen in step.
• The program counter is then incremented, so the cycle repeats with the address of the next instruction to be fetched.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Additional guidance

• A list of correct but independent roles, with no linkage between the components and no reference to the stages of the cycle, is limited to Level 1; an answer that gives the roles of the components but does not link them to the fetch, decode and execute stages is limited to Level 2; a Level 3 answer must cover the control unit/ALU and registers and link them to the stages of the cycle.
• Award no credit for 'the control unit is the brain of the CPU', 'the ALU stores data' or 'registers are the same as RAM'; accept the program counter, MAR, MDR and accumulator as examples of registers, accept the clock, address bus, data bus and control bus where they are linked to a stage of the cycle, and accept 'main memory' or 'RAM' as equivalent.