Edexcel GCSE Computer Science (1CP2) Exam Questions

• A Address bus (1)
• The only correct answer is A. The correct answer is address bus. Do not accept 'address' on its own.
• B is not correct because the control bus carries control signals in both directions between the CPU and other components
• C is not correct because the data bus carries data in both directions between the CPU and main memory
• D is not correct because the system bus is the collection of all three buses

Award one mark for:

• Laser (1)

Allow laser beam

Do not accept read/write head

Do not accept pits

Do not accept lands

Do not accept reflective surface

Do not accept magnet/magnetic

Award one mark for any of the following up to a maximum of two marks:

• A binary digit (1)
• Has the value 0 or 1 (1)
• The smallest unit of data storage (1)
• A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Award up to two marks for a linked description such as:

• Parts of a file are moved so they are stored together/in consecutive locations (1) so the read/write head has less distance to travel to read the file (1)
• Files are rearranged so that each file is stored in one block (1) which reduces the time taken to open/load the file (1)
• Free space on the disk is collected into one area (1) so new files can be saved without becoming fragmented (1)
• The parts of each fragmented file are put in order (1) so fewer movements of the read/write head are needed to read it (1)

Do not accept responses about compressing files, deleting files or increasing the amount of storage, as these are not what defragmentation software does.

Do not accept 'it makes the disk faster' without saying how the files are changed.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Award one mark for each correct nibble in the correct order:

• 0100 (1)
• 0000 (1)

0 marks if the response is not 8-bit binary.

Indicative content

Types of backup that could be used

• A full backup copies all of the company's project files every time it is run, so the whole set of files is held together in one backup.
• A full backup takes longer to make and needs more storage space than an incremental backup.
• An incremental backup copies only the files that have changed since the previous backup, so it is quicker to run each evening.
• Restoring from incremental backups needs the last full backup plus every incremental backup made since, which takes longer and is more complex.
• A weekly full backup with nightly incremental backups can be suitable for the company when the reason is explained using the properties of the two types.

Where and how often backups should be made

• Backups should be kept on a separate device and, ideally, at a different location, so that a fire or theft in the office cannot destroy the computer and the backups together.
• Backups should be made regularly, for example every evening, so that at most one day's design work would be lost.
• Cloud storage can hold copies off-site automatically, without the owner taking a disk home.
• An external hard disk or USB flash drive can be used as the backup medium, with a copy kept away from the office.

How the backups would be used if the hard disk failed again

• If the hard disk fails again, the backup software is used to restore the latest full backup and any later incremental backups onto a replacement disk.
• The restored project files allow the company to carry on working and meet its clients' deadlines.
• The backups should be tested by restoring a file so that the company knows the backup is usable before it is needed.
• Backup software does not repair the failed hard disk itself, so a replacement disk is still needed.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 requires all three bullets to be developed and applied, including both types of backup (or a justified combination) and a restoration sequence; a response that describes only a full backup cannot reach Level 3.

An answer that explains only one type of backup with at most a brief location or frequency point and no developed restoration is Level 1 (1–2 marks). Credit one off-site point only: cloud storage, an external disk kept elsewhere and 'a different location' are the same point. Do not accept that backup software repairs a failed hard disk or recovers files that were never backed up; an answer that only makes this claim is Level 0. An unsupported weekly-full/nightly-incremental recommendation is not credited.