Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markStored Program Computers Swap Remove

Identify the bus that carries addresses in one direction only, from the CPU to main memory.

[1 mark]
  • AAddress bus
  • BControl bus
  • CData bus
  • DSystem bus
Mark scheme
  • A Address bus (1)
  • The only correct answer is A. The correct answer is address bus. Do not accept 'address' on its own.
  • B is not correct because the control bus carries control signals in both directions between the CPU and other components
  • C is not correct because the data bus carries data in both directions between the CPU and main memory
  • D is not correct because the system bus is the collection of all three buses
Example answers and how they were marked
Full marks1/1

A Address bus

Why: Correct option: the address bus carries addresses in one direction only, from the CPU to main memory (1).

No marks0/1

C Data bus

Why: The data bus carries data in both directions, so it is not the bus that carries addresses in one direction only from the CPU to main memory; no creditworthy point.

No marks0/1

B Control bus

Why: The control bus carries control signals in both directions, not addresses in one direction only; this is the common control/address bus confusion, so no mark.

2Short recall2 marksPrimary Memory Swap Remove

A computer is designed using the von Neumann stored program concept.

Define the term stored program concept.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • The program instructions and data are stored together in main memory/RAM (1)
  • The same memory is used for both instructions and data (1)
  • The instructions are fetched from main memory and executed by the CPU (1)
  • The instructions are fetched and executed one at a time / in sequence (1)
  • The program can be changed/replaced by loading new instructions into memory, without changing the hardware (1)

Do not accept the program is stored in secondary storage / on the hard disk.

Do not accept the program is stored in the CPU / in registers.

Example answers and how they were marked
Full marks2/2

The program instructions and the data are stored together in main memory, and the CPU fetches the instructions one at a time and executes them.

Why: Creditworthy point that instructions and data are stored in the same main memory (1) and the linked point that the CPU fetches and executes them from memory (1).

Some marks1/2

The program is held in the main memory (RAM) so that the computer can run it.

Why: Earns the point that the program instructions are stored in main memory (1), but does not say that the CPU fetches and executes them, so the second mark is not earned.

No marks0/2

The program is stored on the hard disk and loaded into the CPU when it is run.

Why: Both parts are misconceptions named in the Do not accept lines: the stored program concept keeps the instructions in main memory, not on secondary storage or in the CPU.

3Short recall2 marksSecondary Memory Swap Remove

Computers have both primary storage and secondary storage.

Define the term secondary storage.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • (Storage that is) non-volatile / keeps its data when the power is turned off (1)
  • (Storage that is) used to store programs and data/files (for later use) (1)
  • (Storage that is) not directly accessible by the CPU / not directly accessed by the CPU (1)

Allow both the non-volatile point and the stores programs and data point from one sentence if each idea is clearly stated, e.g. 'non-volatile storage that holds programs and data'.

Allow accessed via the CPU / must be copied into RAM before the CPU can use it for the third point.

Do not accept volatile / loses its data when the power is turned off.

Do not accept a description of primary storage, such as RAM or ROM.

Do not accept capacity.

Do not accept an example device on its own (e.g. hard disk drive).

Example answers and how they were marked
Full marks2/2

Secondary storage is non-volatile, so it does not lose data when the power is turned off. It is used to store programs and data files for later use.

Why: Non-volatile / keeps data when the power is off (1) and used to store programs and data files (1), each idea clearly stated.

Some marks1/2

Secondary storage is used to store programs and data files.

Why: Stores programs and data/files (1), but nothing is said about it being non-volatile or not directly accessible by the CPU.

No marks0/2

Secondary storage is volatile memory that holds the data the CPU is using at the moment.

Why: Describes primary storage (RAM) and says it is volatile, which the mark scheme says not to accept, so no marks are awarded.

4Explain2 marksEmbedded Systems Swap Remove

An engine control unit (ECU) in a car is an embedded system.

Explain one benefit of using an embedded system for the engine control unit instead of a general purpose computer.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • (The ECU) is more reliable/less likely to crash (1) because it only runs the one program/has a single purpose (1)
  • (The ECU) cannot be affected by other software/viruses (1) because it cannot run other software/it can only run the program it was made for (1)
  • (The ECU) is cheaper (1) because it has limited processing resources/less memory/simple components (1)
  • (The ECU) uses less power (1) because it has limited processing resources/a simpler processor (1)
  • (The ECU) is smaller (1) because it has fewer components/less memory than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

A suitable benefit stated on its own earns one mark.

Do not accept a description or a location given as the reason, e.g. 'because it is part of the car', 'because it is inside the engine', 'because it is embedded'.

Do not accept a description of an embedded system on its own as the benefit, e.g. 'it does one specific job' or 'it is part of the car'.

Do not accept 'it is faster'/'it has a more powerful processor' as embedded systems have limited processing resources.

Example answers and how they were marked
Full marks2/2

It is more reliable than a general purpose computer because it only runs the one program so it will not crash and stop the engine working.

Why: Benefit stated (1) with a linked reason (1); the reason shows why only running one program makes it reliable.

Some marks1/2

It is more reliable because it is part of the car's engine.

Why: Only the benefit earns a mark (1); being part of the car is a location, not a linked reason why it is reliable.

No marks0/2

It is faster than a general purpose computer because it is embedded in the engine.

Why: Misconception that an embedded system is faster; embedded systems have limited processing resources, so neither point nor reason is creditworthy.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.