Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 604 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 14 marks

Pick again
Print
1Multiple choice1 markStored Program Computers Swap Remove

Identify the bus that carries addresses in one direction only, from the CPU to main memory.

[1 mark]
  • AAddress bus
  • BControl bus
  • CData bus
  • DSystem bus
Mark scheme
  • A Address bus (1)
  • The only correct answer is A. The correct answer is address bus. Do not accept 'address' on its own.
  • B is not correct because the control bus carries control signals in both directions between the CPU and other components
  • C is not correct because the data bus carries data in both directions between the CPU and main memory
  • D is not correct because the system bus is the collection of all three buses
Example answers and how they were marked
Full marks1/1

A Address bus

Why: Correct option: the address bus carries addresses in one direction only, from the CPU to main memory (1).

No marks0/1

C Data bus

Why: The data bus carries data in both directions, so it is not the bus that carries addresses in one direction only from the CPU to main memory; no creditworthy point.

No marks0/1

B Control bus

Why: The control bus carries control signals in both directions, not addresses in one direction only; this is the common control/address bus confusion, so no mark.

2Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

3Describe2 marksTranslators Swap Remove

High-level code can be translated by a compiler or by an interpreter.

Describe how a compiler translates high-level code differently from an interpreter.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • The compiler translates the whole program/complete source code in one go (1) whereas the interpreter translates one line/statement at a time (1)
  • The compiler translates all of the source code before any of it is run/executed (1) but the interpreter translates each line/statement as it reads it (1)
  • The interpreter translates one line/statement at a time (1) and the compiler translates the whole program/source code together (1)

Accept the compiler point and the interpreter point in either order.

Do not accept responses about object code/executable files, when the translated code is executed, how errors are reported, or speed/memory use.

Do not accept 'the interpreter executes/runs each line' on its own, without saying that it translates one line/statement at a time.

Example answers and how they were marked
Full marks2/2

A compiler translates the whole program in one go, while an interpreter translates one line at a time.

Why: Whole program translated in one go (1) and interpreter translates one line at a time (1).

Some marks1/2

A compiler translates the whole program in one go.

Why: Whole program translated in one go (1); no linked point about the interpreter translating a line at a time.

No marks0/2

A compiler produces an executable file, but an interpreter does not.

Why: Describes the output, not the amount translated at a time; object code/executable files are not accepted.

4Calculate3 marksAdding Binary Numbers Swap Remove

Binary patterns can represent numbers.

(a)

Complete the table to show the 8-bit result of the binary addition.

[2 marks]
1286432168421
11011011
11011100
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 1011 (1)
  • 0111 (1)

0 marks if the response is not 8-bit binary.

Ignore a carry shown beyond the eighth bit.

Example answers and how they were marked
Full marks2/2

1011 0111

Why: 219 + 220 = 439, which needs 9 bits; the 8 bits that are kept are both correct (2).

Some marks1/2

0000 0111

Why: Forgets to carry the 1s. The second nibble is correct (1); the first is not.

No marks0/2

1101 1111

Why: Never carries. Neither nibble is correct.

(b)

State the name of the error that occurs when this addition is carried out.

[1 mark]
Mark scheme

Award one mark for:

  • overflow (error) (1)
Example answers and how they were marked
Full marks1/1

Overflow

Why: The result needs more bits than are available (1).

No marks0/1

Underflow

Why: A near miss: the result is too big for 8 bits, not too small.

No marks0/1

A syntax error

Why: A syntax error is a mistake in a program's code, not in arithmetic.

5Discuss6 marksLow and High Level Languages Swap Remove

A software company is writing a new program that will be sold to users who have different types of computer. The program does not need to control the hardware of the computer directly. The company must decide whether to write the program in a high-level language or a low-level language.

Discuss whether the company should use a high-level language or a low-level language to write this program.

Your answer should consider:

  • machine independence
  • processor specificity
  • how the code is translated for each type of computer.
[6 marks]
Mark scheme

Indicative content

Machine independence

  • A high-level language is machine independent, so the same source code can be run on different types of computer with few or no changes.
  • The company can write the program once and sell it to users with different computers, without rewriting the code for each type of computer.
  • Only one version of the program needs to be written and maintained, so development takes the company less time.

Processor specificity

  • A low-level language is processor-specific, so a program written for one processor will not run on a different processor without being rewritten.
  • Assembly language instructions depend on the instruction set of the particular processor, so the company would need a separate version of the program for each type of computer.
  • Writing a separate low-level version for every type of computer would take the company much longer than writing one high-level program.
  • Low-level code gives direct control of the hardware of one processor, so it is better suited to device drivers than to a program that must run on many different computers.

Translation

  • High-level source code is translated for each type of computer by a compiler or an interpreter, so one version of the source code is enough for all the users.
  • Assembly language is translated into machine code by an assembler, and the assembler produces machine code for one specific processor only.
  • Machine code is already in a form that one particular processor can execute directly, but the same machine code will not run on a different processor.
  • Each high-level statement translates into several machine code instructions, so the programmer does not need to know the instruction set of the processor.

Levels

  • Level 0 (0 marks): No rewardable content.
  • Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
  • Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
  • Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Additional guidance

  • Level 3 responses must cover both high-level machine independence and low-level processor specificity, with the effect on the company's decision.
  • Do not award low-level language, assembly language or machine code as portable, or 'high-level languages are written in English/like English' as a reason for machine independence.
Example answers and how they were marked
Full marks6/6

A high-level language is machine independent, so the company can write the program once and it will run on different types of computer with few or no changes. A different compiler is used for each type of processor to translate that same source code into the machine code for that computer, so the company can sell one program to all of its users. A low-level language is processor-specific, so a program written in assembly for one processor will not run on a different one. The assembler produces machine code for one particular instruction set, so the company would need to write a separate version for each type of computer, which would take much longer. As the program does not need to control the hardware directly, the company should use a high-level language.

Why: Develops high-level machine independence with the compiler translating for each processor, and low-level processor specificity with the assembler producing machine code for one instruction set, both applied to the company's decision, in a coherent and sustained argument: Level 3, 6 marks.

Some marks3/6

A high-level language is machine independent, so the company can write the program once. A different compiler is used for each type of computer to translate the code, so users with different computers can all run the same program. A low-level language is processor-specific, so it would not be as suitable for the company.

Why: Machine independence is linked to the compiler and applied to the users, but processor specificity is only asserted and no translation of low-level code is given, so the reasoning is not sustained: Level 2, 3 marks.

Some marks1/6

High-level languages are machine independent because they are written in English, so the company can sell the program to anyone. Low-level languages are machine code, so they can be translated to run on any type of computer.

Why: One basic point that high-level languages are machine independent, applied by selling to anyone (1). 'Written in English' is not a reason for machine independence and low-level code is not portable, so neither is credited: Level 1, 1 mark.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.