Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 604 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markStored Program Computers Swap Remove

Identify the bus that carries addresses in one direction only, from the CPU to main memory.

[1 mark]
  • AAddress bus
  • BControl bus
  • CData bus
  • DSystem bus
Mark scheme
  • A Address bus (1)
  • The only correct answer is A. The correct answer is address bus. Do not accept 'address' on its own.
  • B is not correct because the control bus carries control signals in both directions between the CPU and other components
  • C is not correct because the data bus carries data in both directions between the CPU and main memory
  • D is not correct because the system bus is the collection of all three buses
Example answers and how they were marked
Full marks1/1

A Address bus

Why: Correct option: the address bus carries addresses in one direction only, from the CPU to main memory (1).

No marks0/1

C Data bus

Why: The data bus carries data in both directions, so it is not the bus that carries addresses in one direction only from the CPU to main memory; no creditworthy point.

No marks0/1

B Control bus

Why: The control bus carries control signals in both directions, not addresses in one direction only; this is the common control/address bus confusion, so no mark.

2Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

3Describe2 marksMemory Management Swap Remove

The operating system is held in main memory while the computer is running.

Describe how the operating system stops a running program from overwriting memory that is not its own.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • It keeps a record of which memory addresses/areas belong to each program and to the operating system (1) so it knows which addresses a program is allowed to use (1)
  • Each program is given its own area of main memory (1) so a program cannot write to the addresses used by another program or by the operating system (1)
  • The memory used by the operating system is marked as protected/reserved (1) so a program that tries to write to it is blocked/causes an error (1)
  • The address a program writes to is checked against the record of its allocated area (1) and the write is stopped if the address is outside that area (1)

Allow the memory being protected to be that of the operating system or of another program.

For both marks, the expansion must follow/associate with the statement.

Do not award generic answers such as 'the operating system manages memory' or 'the operating system keeps track of memory'.

Do not award responses about stopping programs using too much memory or allocating memory, as these are not about protecting memory being overwritten.

Do not award responses about virtual memory, paging or moving processes to secondary storage.

Do not award responses about firewalls, antivirus software or passwords.

Example answers and how they were marked
Full marks2/2

The operating system gives each program its own area of main memory so that a program cannot write to the addresses used by another program or by the operating system.

Why: Each program is given its own area of main memory (1) linked to it not being able to write to the addresses used by another program or the operating system (1).

Some marks1/2

The operating system gives each program its own area of main memory.

Why: Each program is given its own area of main memory (1), but there is no linked development saying how this stops a program overwriting memory that is not its own.

No marks0/2

The operating system stops a program overwriting memory by moving it into virtual memory when it uses too much.

Why: This describes virtual memory and limiting how much memory a program uses, not protecting memory from being overwritten, so neither bullet applies and the Do not award lines rule it out.

4Describe2 marksLow and High Level Languages Swap Remove

A programmer has written a program in assembly language.

Describe why it is necessary to translate the program into machine code before it can be run.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • The processor/CPU can only execute machine code/binary instructions (1) so the assembly instructions must be converted into machine code before the program can run (1)
  • Each assembly instruction/mnemonic matches/corresponds to one machine code instruction (1) so each line must be replaced with the machine code the processor executes (1)
  • The program is written using mnemonics (1) that must be translated into machine code for the processor to carry out the instructions (1)
  • The hardware/processor does not understand assembly language directly (1) so it must be translated into machine code that the processor can execute (1)

Do not accept 'assembly language is a low-level language'.

Do not accept 'it is hard to understand' or 'it is not English'.

Do not accept benefits, such as 'machine code runs faster' or 'the program will run more quickly'.

Do not accept 'an assembler/a translator converts it' on its own, with no reference to the processor only being able to execute machine code/binary.

Do not accept responses about high-level languages or about compilers/interpreters.

Example answers and how they were marked
Full marks2/2

The processor can only execute machine code, so the assembly instructions must be converted into machine code before the program can run.

Why: States what the processor can execute (1) and links it to converting the program's instructions into machine code (1).

Some marks1/2

Each assembly instruction matches one machine code instruction.

Why: Correct point about the one-to-one match (1) but no development saying that this is because the processor only executes machine code.

No marks0/2

Because an assembler translates assembly language into machine code.

Why: Names the translator but gives no reason tied to the processor only being able to execute machine code, so no mark; this is in the 'Do not accept' guidance.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 18
Data Protection Act 14 questions Impact of AI 4 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.