Edexcel GCSE Computer Science (1CP2) Exam Questions

• A Decodes instructions (1)
• The only correct answer is A. The correct answer is Decodes instructions.
• B is not correct because the arithmetic logic unit performs arithmetic operations
• C is not correct because main memory stores data and instructions
• D is not correct because registers temporarily store data being processed

• C 128 (1)
• The only correct answer is C. The correct answer is 128.
• A is not correct because 6 bits give only 64 different combinations
• B is not correct because 127 is the largest 7-bit value, not the number of characters that 7 bits can represent
• D is not correct because 256 characters need 8 bits, as used by 8-bit extended ASCII

Award one mark for any of the following up to a maximum of two marks:

• Program instructions are stored in main memory/RAM (1)
• The data used by the program is stored in main memory/RAM (1)
• The CPU fetches/reads instructions from main memory to execute them (1)
• The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Award one mark for each correct nibble in the correct order:

• 1110 (1)
• 0100 (1)

0 marks if the response is not 8-bit binary.