Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 631 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markStored Program Computers Swap Remove

Identify the function of the control unit in the fetch-decode-execute cycle.

[1 mark]
  • ADecodes instructions
  • BPerforms arithmetic operations
  • CStores data and instructions
  • DTemporarily stores data being processed
Mark scheme
  • A Decodes instructions (1)
  • The only correct answer is A. The correct answer is Decodes instructions.
  • B is not correct because the arithmetic logic unit performs arithmetic operations
  • C is not correct because main memory stores data and instructions
  • D is not correct because registers temporarily store data being processed
Example answers and how they were marked
Full marks1/1

A Decodes instructions

Why: Correct option: the control unit decodes instructions during the fetch-decode-execute cycle (1).

No marks0/1

C Stores data and instructions

Why: Main memory stores data and instructions, not the control unit; this is a common distractor, so no mark.

No marks0/1

B Performs arithmetic operations

Why: Arithmetic operations are performed by the ALU, not the control unit; a common confusion between CPU components, so no mark.

2Short recall2 marksStored Program Computers Swap Remove

Computers use the von Neumann stored program concept.

Define the term stored program concept.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Program instructions are stored in main memory/RAM (1)
  • The data used by the program is stored in main memory/RAM (1)
  • The CPU fetches/reads instructions from main memory to execute them (1)
  • The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Example answers and how they were marked
Full marks2/2

Both the program instructions and the data the program uses are held in the same main memory, and the CPU fetches these instructions from memory to execute them.

Why: Instructions stored in main memory (1) and the CPU fetches instructions from memory to execute them (1).

Some marks1/2

Program instructions are stored in main memory.

Why: Instructions stored in main memory (1). No second point about data being stored in the same memory or about the CPU fetching instructions.

No marks0/2

The program is saved on the hard disk so that it can be loaded into RAM when the user runs it.

Why: A near-miss about secondary storage, which the mark scheme says not to accept; the stored program concept is about instructions being held in main memory.

3Describe2 marksSecondary Memory Swap Remove

A laptop uses a solid state drive (SSD) for secondary storage.

Describe how data is stored on a solid state drive.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Data is stored on (flash) memory chips/cells (1) as a pattern of electrical charges (1)
  • A current/voltage forces electrons through a barrier (1) so that they are trapped (or not trapped) to hold/represent a value (1)
  • Cells with a trapped charge and cells with no trapped charge (1) represent 1s and 0s/binary (1)
  • The trapped charge remains when the power is turned off (1) so the data is not lost/it is non-volatile (1)

Do not accept responses that describe magnetic storage, e.g. magnetised platters, spinning disks or read/write heads, or optical storage, e.g. lasers, pits and lands.

Do not award a mark for 'it is solid state' or 'it has no moving parts' without a description of how the data is stored.

Do not award a mark for restating the stem, e.g. 'a laptop uses an SSD' or 'an SSD uses flash memory'.

'Data is stored as electrical charges' on its own, with no reference to memory chips/cells or to how the charge is held, earns a maximum of one mark (1).

A response that only describes electrons being trapped, with no link to how the value/data is represented, earns one mark (1). The second mark needs a link such as trapped and not trapped charge representing 1s and 0s, or the trapped charge being kept so the data is not lost.

Example answers and how they were marked
Full marks2/2

A current is used to force electrons through a barrier so that they become trapped, and a cell with a trapped charge or a cell with no trapped charge represents a 1 or a 0.

Why: Linked description: a current forces electrons through a barrier (1) and trapped/not trapped charge represents 1s and 0s (1).

Some marks1/2

The data is stored in flash memory chips.

Why: Gives the creditworthy point that data is stored on flash memory chips (1) but does not develop it, e.g. by saying the data is held as electrical charges or by describing trapped electrons.

No marks0/2

The data is stored as magnetised areas on a spinning platter.

Why: This describes magnetic storage, which the mark scheme says not to accept for a solid state drive.

4Explain2 marksEmbedded Systems Swap Remove

A greenhouse uses an embedded system to keep the plants healthy.

Explain how the embedded system controls the temperature in the greenhouse.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • A temperature sensor measures/reads the temperature in the greenhouse (1) which the processor compares with the value stored in the system (1)
  • The heater is switched on (1) when the temperature reading goes below the value stored in the system (1)
  • A fan/vent/window is opened/a cooler is switched on (1) when the temperature reading goes above the value stored in the system (1)
  • The temperature is checked/measured continuously (1) so the heater/fan is switched on or off as soon as the temperature changes (1)

For both marks, the expansion must follow/associate with the statement.

Allow one mark for a correct point on its own without a linked reason, e.g. 'a temperature sensor measures the temperature'.

Do not award 'the embedded system controls/keeps the temperature correct' as this repeats the question.

Do not accept naming a device without saying what it does, e.g. 'the greenhouse has a thermostat'.

Example answers and how they were marked
Full marks2/2

A temperature sensor measures the temperature in the greenhouse, which the processor compares with the value stored in the system.

Why: Point (1): the input and what it measures. Reason (1): the linked statement about what the processor does with the reading.

Some marks1/2

The embedded system uses a temperature sensor that measures the temperature in the greenhouse.

Why: A correct point on its own (1); no linked statement about what the system does with the reading, so the second mark is not awarded.

No marks0/2

The embedded system controls the temperature so the plants do not get too cold.

Why: Rewords the question without saying how the temperature is measured or changed, so no mark is awarded.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 45
Data Protection Act 17 questions Impact of AI 16 questions Intellectual Property 12 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.