Edexcel GCSE Computer Science (1CP2) Exam Questions

• A Decodes instructions (1)
• The only correct answer is A. The correct answer is Decodes instructions.
• B is not correct because the arithmetic logic unit performs arithmetic operations
• C is not correct because main memory stores data and instructions
• D is not correct because registers temporarily store data being processed

• B 4 (1)
• The only correct answer is B. The correct answer is 4 (2 bits give 2^2 = 4 values).
• A is not correct because 2 is the number of bits used to store each sample
• C is not correct because 8 different amplitude values would need 3 bits
• D is not correct because 16 different amplitude values would need 4 bits

Award one mark for:

• Laser (1)

Allow laser beam

Do not accept read/write head

Do not accept pits

Do not accept lands

Do not accept reflective surface

Do not accept magnet/magnetic

Award one mark for each of:

• 5 × 1024^3 / 5 × 1024 × 1024 × 1024 / 5 × 2^30, for the number of bytes (1)
• A fully correct expression with × 8 to convert bytes to bits, in any order, e.g. 5 × 1024^3 × 8, 8 × 5 × 2^30 (1)

Accept 5 × 1 073 741 824 × 8.

Accept 5 × 2^33 or 42 949 672 960 as a fully correct expression (2 marks).

Do not accept 5 × 1000^3 × 8, which uses decimal multiples.

Do not accept ÷ 8, which converts bits to bytes.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Award one mark for each correct nibble in the correct order:

• 1110 (1)
• 0100 (1)

0 marks if the response is not 8-bit binary.