Edexcel GCSE Computer Science (1CP2) Exam Questions

Award one mark for any of the following up to a maximum of three marks:

• Control unit / CU (1)
• Arithmetic logic unit / ALU (1)
• Register(s) (1)
• Clock (1)

Do not accept main memory / RAM.

Do not accept cache.

Marks can be awarded in any order.

Award one mark for any of the following up to a maximum of two marks:

• A binary digit (1)
• Has the value 0 or 1 (1)
• The smallest unit of data storage (1)
• A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Award up to two marks for a linked description such as:

• The program (and its data) is copied/loaded from secondary storage into main memory/RAM (1) so that the CPU can fetch/execute its instructions (1)
• An area of main memory is allocated/reserved for the program (1) that is large enough to hold the program and its data (1)
• The operating system checks that there is enough free main memory (1) before the program can be started/loaded, otherwise it cannot run/an error is reported (1)
• The operating system keeps a record of the memory addresses used by the program (1) so that its instructions and data can be found when it runs (1)

Allow 'loaded into RAM', 'stored in memory' and 'put into main memory' as equivalent to copied into main memory.

A single statement that the program is loaded/stored in main memory, with no linked development, can be given one mark only.

Do not accept descriptions of the CPU fetching/executing instructions that do not refer to the operating system loading or allocating memory.

Do not accept responses about virtual memory (moving processes to secondary storage) or about which process runs next on the CPU.

Do not accept the program being run from secondary storage/hard disk.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.