Edexcel GCSE Computer Science (1CP2) Exam Questions

Award one mark for any of the following up to a maximum of two marks:

• Program instructions are stored in main memory/RAM (1)
• The data used by the program is stored in main memory/RAM (1)
• The CPU fetches/reads instructions from main memory to execute them (1)
• The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Award up to two marks for a linked description such as:

• It is a computer/processor built into a larger device (1) to carry out a single dedicated task/function (1)
• It is a combination of a processor, memory and input/output in one unit (1) that controls the device it is part of (1)
• It is a computer that forms part of another device (1) so it is not used as a general purpose computer (1)

Allow 'forms part of another device' or 'inside another device' for the first mark.

Do not award the second mark for a separate fact that is not linked to the first point, e.g. 'It is built into a device and it uses little power' would earn only the first mark (1).

Do not accept 'a small computer' on its own, with no reference to being part of another device or performing a dedicated task.

Do not accept 'a computer that controls a device' on its own, with no reference to it being built into/part of a larger device or carrying out a dedicated task.

Do not accept 'it performs a single dedicated task' on its own, with no reference to it being built into/part of a larger device.

Do not accept descriptions of a general purpose computer, e.g. 'it can run many different programs' or 'new software can be installed'.

Do not accept 'it is a system that is embedded in another system' as this repeats the term in the question.

Award up to two marks for a linked description such as:

• Data is stored on (flash) memory chips/cells (1) as a pattern of electrical charges (1)
• A current/voltage forces electrons through a barrier (1) so that they are trapped (or not trapped) to hold/represent a value (1)
• Cells with a trapped charge and cells with no trapped charge (1) represent 1s and 0s/binary (1)
• The trapped charge remains when the power is turned off (1) so the data is not lost/it is non-volatile (1)

Do not accept responses that describe magnetic storage, e.g. magnetised platters, spinning disks or read/write heads, or optical storage, e.g. lasers, pits and lands.

Do not award a mark for 'it is solid state' or 'it has no moving parts' without a description of how the data is stored.

Do not award a mark for restating the stem, e.g. 'a laptop uses an SSD' or 'an SSD uses flash memory'.

'Data is stored as electrical charges' on its own, with no reference to memory chips/cells or to how the charge is held, earns a maximum of one mark (1).

A response that only describes electrons being trapped, with no link to how the value/data is represented, earns one mark (1). The second mark needs a link such as trapped and not trapped charge representing 1s and 0s, or the trapped charge being kept so the data is not lost.

Award up to two marks for a linked explanation such as:

• Decodes/interprets/translates the instruction (1) to work out what the instruction is/what operation is required (1)
• Sends control signals to the other components (1) so that the correct component carries out the instruction (1), e.g. the ALU/main memory
• Controls the fetch of the instruction from main memory (1) because the address of the next instruction is sent via the address bus (1)
• Controls the fetch of the next instruction from main memory (1) by sending a control signal/read signal to main memory (1)

For both marks, the expansion must follow/associate with the statement.

For the decode point, 'decodes the instruction' alone gains 1 mark; a second mark needs the purpose of decoding, i.e. working out what the instruction is/what operation is required.

Do not accept 'it controls the CPU' on its own, without naming a task in the cycle.

Do not accept 'it fetches the instruction from memory' on its own, as this describes the fetch step rather than the control unit's role; credit only if linked to controlling/signalling the fetch.

Do not accept carrying out arithmetic/logical operations, as these are carried out by the ALU, or holding the address of the next instruction, as this is the program counter.

Do not accept storing the instruction in a register (e.g. MAR/MDR), as this is not the role of the control unit.