Edexcel GCSE Computer Science (1CP2) Exam Questions

Award one mark for any of the following up to a maximum of two marks:

• Program instructions are stored in main memory/RAM (1)
• The data used by the program is stored in main memory/RAM (1)
• The CPU fetches/reads instructions from main memory to execute them (1)
• The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Award one mark for each of:

• 5 × 1024^3 / 5 × 1024 × 1024 × 1024 / 5 × 2^30, for the number of bytes (1)
• A fully correct expression with × 8 to convert bytes to bits, in any order, e.g. 5 × 1024^3 × 8, 8 × 5 × 2^30 (1)

Accept 5 × 1 073 741 824 × 8.

Accept 5 × 2^33 or 42 949 672 960 as a fully correct expression (2 marks).

Do not accept 5 × 1000^3 × 8, which uses decimal multiples.

Do not accept ÷ 8, which converts bits to bytes.

Award up to two marks for a linked description such as:

• The program (and its data) is copied/loaded from secondary storage into main memory/RAM (1) so that the CPU can fetch/execute its instructions (1)
• An area of main memory is allocated/reserved for the program (1) that is large enough to hold the program and its data (1)
• The operating system checks that there is enough free main memory (1) before the program can be started/loaded, otherwise it cannot run/an error is reported (1)
• The operating system keeps a record of the memory addresses used by the program (1) so that its instructions and data can be found when it runs (1)

Allow 'loaded into RAM', 'stored in memory' and 'put into main memory' as equivalent to copied into main memory.

A single statement that the program is loaded/stored in main memory, with no linked development, can be given one mark only.

Do not accept descriptions of the CPU fetching/executing instructions that do not refer to the operating system loading or allocating memory.

Do not accept responses about virtual memory (moving processes to secondary storage) or about which process runs next on the CPU.

Do not accept the program being run from secondary storage/hard disk.

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.