Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 9 marks

Pick again
Print
1Short recall2 marksStored Program Computers Swap Remove

Computers use the von Neumann stored program concept.

Define the term stored program concept.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Program instructions are stored in main memory/RAM (1)
  • The data used by the program is stored in main memory/RAM (1)
  • The CPU fetches/reads instructions from main memory to execute them (1)
  • The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Example answers and how they were marked
Full marks2/2

Both the program instructions and the data the program uses are held in the same main memory, and the CPU fetches these instructions from memory to execute them.

Why: Instructions stored in main memory (1) and the CPU fetches instructions from memory to execute them (1).

Some marks1/2

Program instructions are stored in main memory.

Why: Instructions stored in main memory (1). No second point about data being stored in the same memory or about the CPU fetching instructions.

No marks0/2

The program is saved on the hard disk so that it can be loaded into RAM when the user runs it.

Why: A near-miss about secondary storage, which the mark scheme says not to accept; the stored program concept is about instructions being held in main memory.

2Short recall1 markUnits & Conversion Swap Remove

A file has a size of 2 kibibytes.

State the number of bytes in the file.

[1 mark]
Mark scheme

Award one mark for:

  • 2048 (1)
  • 2 × 1024 (1)
  • 2^11 (1)

Allow 2048 bytes.

Do not accept 2000, which is the number of bytes in two decimal kilobytes.

Do not accept 1024, which is the number of bytes in one kibibyte.

Do not accept 16, which is the number of bits in two bytes.

Example answers and how they were marked
Full marks1/1

2048

Why: 2048 is 2 × 1024, the number of bytes in 2 kibibytes (1).

No marks0/1

2000

Why: 2000 uses the decimal kilobyte, not the binary kibibyte; the mark scheme does not accept it.

No marks0/1

16

Why: 16 is the number of bits in two bytes, confusing bits with bytes; the mark scheme does not accept it.

3Describe2 marksUtility Software Swap Remove

A computer can lose power while a file is being saved.

Describe what file repair software does.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Attempts to repair/rebuild the corrupted file (1) so that it can be opened by its program again (1)
  • Recovers/retrieves the parts of the file that can still be read (1) so that the user does not lose all of the data in the file (1)
  • Reconstructs the file from data held in other parts of the disk (1) because part of the file/the disk is corrupted (1)
  • Saves a new/repaired copy of the file (1) as some of the data in it may not be recoverable (1)

Do not accept 'it repairs the file' on its own, as this repeats the question.

Do not accept responses about restoring a backup/previous version of the file, as this is backup software.

Do not accept responses about scanning for or removing malware.

Example answers and how they were marked
Full marks2/2

It recovers the parts of the file that can still be read (1) so that the user does not lose everything that was saved in it (1).

Why: The point (1) and a linked development giving the effect (1).

Some marks1/2

It rebuilds the damaged file from other parts of the disk.

Why: A valid point is made (1) but there is no development of what this achieves, so the second mark is not awarded.

No marks0/2

It restores the last backup of the file so the user gets the data back.

Why: This describes backup software, which the mark scheme does not accept for this question.

4Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

5Calculate2 marksBinary Shifts Swap Remove

Computers manipulate binary patterns.

Complete the table with the result of applying the shift to the binary pattern.

[2 marks]
Binary patternShift8-bit binary result
1000 0001Logical shift right by 1
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 0100 (1)
  • 0000 (1)

0 marks if the response is not 8-bit binary.

Example answers and how they were marked
Full marks2/2

0100 0000

Why: Every bit moves 1 place right, with 0s in from the left: both nibbles are correct (2).

Some marks1/2

0100 0001

Why: A slip in the last bit. The first nibble is correct (1); the second is not.

No marks0/2

0000 0010

Why: Shifts the bits the wrong way. Neither nibble is correct.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.