Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 14 marks

Pick again
Print
1Short recall2 marksStored Program Computers Swap Remove

Computers use the von Neumann stored program concept.

Define the term stored program concept.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Program instructions are stored in main memory/RAM (1)
  • The data used by the program is stored in main memory/RAM (1)
  • The CPU fetches/reads instructions from main memory to execute them (1)
  • The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Example answers and how they were marked
Full marks2/2

Both the program instructions and the data the program uses are held in the same main memory, and the CPU fetches these instructions from memory to execute them.

Why: Instructions stored in main memory (1) and the CPU fetches instructions from memory to execute them (1).

Some marks1/2

Program instructions are stored in main memory.

Why: Instructions stored in main memory (1). No second point about data being stored in the same memory or about the CPU fetching instructions.

No marks0/2

The program is saved on the hard disk so that it can be loaded into RAM when the user runs it.

Why: A near-miss about secondary storage, which the mark scheme says not to accept; the stored program concept is about instructions being held in main memory.

2Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

3Describe2 marksLow and High Level Languages Swap Remove

A device driver is software that allows the operating system to control a piece of hardware. Device drivers are often written in a low-level programming language.

Describe one reason why a low-level programming language is suitable for writing a device driver.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
  • The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
  • The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
  • Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Example answers and how they were marked
Full marks2/2

Low-level instructions can manipulate the hardware and memory directly (1) so the driver can control the specific device it was written for, such as a sound card (1).

Why: Point about direct control of hardware/memory (1) linked to controlling the specific device (1). The named device is extra detail and is not needed.

Some marks1/2

Low-level instructions can manipulate the hardware directly.

Why: Correct point (1) but no linked development saying how this helps the device driver.

No marks0/2

It is closer to machine code so it runs faster than a high-level language.

Why: 'Closer to machine code' is not developed into how this helps the driver, and 'runs faster' is not linked to the hardware/device, so no mark.

4Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

5Discuss6 marksTranslators Swap Remove

A company writes a photo editing program in a high-level language. The company will sell the finished program to customers. Each customer will install the program on their own computer and run it many times.

Discuss whether the company should use a compiler or an interpreter to translate the program before it is sold.

Your answer should include:

  • the output of each type of translator
  • whether the program has to be translated each time it is run
  • what the customer needs on their computer to run the program.
[6 marks]
Mark scheme

Indicative content

The output of each type of translator

  • A compiler translates the whole program in one go and produces object code.
  • The object code is saved as an executable file, which is already in machine code so the processor can run it directly.
  • An interpreter does not produce object code, so no translated file exists for the company to save and sell.
  • An interpreter translates one line at a time and executes it immediately, but that translation is not kept.

Whether the program has to be translated each time it is run

  • Compiled code is translated once, so the executable can be run as many times as the customer likes without being translated again.
  • If the source code is edited, the whole program has to be compiled again to produce a new executable.
  • An interpreted program is translated again every time it is run, so a customer who runs the program often waits for translation at every run.
  • An executable runs faster than interpreted code because it is already in machine code.

What the customer needs on their computer to run the program

  • A customer who installs the executable needs no compiler on their computer, so the program will run straight away.
  • If the company supplied the source code instead, the customer would need an interpreter installed, and it would have to be an interpreter for their type of computer.
  • A customer given only the executable does not have the source code, so cannot change the program.

Conclusion

  • A compiler is the better choice for this company, because the executable can be sold and the customer runs it without it being translated again and without being given the source code.
  • Using an interpreter would mean supplying the source code to customers and translating the program on every run.

Levels

  • Level 0 (0 marks): No rewardable content.
  • Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
  • Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
  • Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 responses must cover all three bullets for this company's program, including translating once rather than on every run, and reach a conclusion.

Do not accept 'a compiler fixes errors' (a compiler reports syntax errors at the end of translation, it does not fix them) or 'a compiler is easier to use' with no link to output, translation or the customer. Do not accept answers about translating to assembly language.

Example answers and how they were marked
Full marks6/6

The company should use a compiler. A compiler translates the whole program in one go and produces object code, which is saved as an executable file. This executable is already in machine code, so the customer's processor can run it directly. The program is translated only once, so a customer who runs the program many times does not wait for it to be translated again, and it runs faster than interpreted code would. An interpreter produces no object code, so the company would have nothing to sell as an executable. The customer would have to be given the source code and would need an interpreter installed on their computer, and the program would be translated again every time it was run.

Why: Level 3. Covers the output of both translators (executable from the compiler, no object code from the interpreter), the effect of translating once rather than on every run, and what the customer needs on their computer, all applied to the company selling the program, with a clear conclusion.

Some marks3/6

A compiler produces an executable file, which the company can save and sell to its customers. An interpreter does not produce an executable file, so the customer would need the source code and an interpreter installed on their computer to run the program. This means a compiler is better for the company, because customers can just run the file they are given.

Why: Level 2. Gives the output of both translators and links this to what the customer needs, with a conclusion, but never says the compiled program is translated once while an interpreted one is translated on every run, so the reasoning is not developed enough for Level 3.

No marks0/6

The company should use a compiler because it is easier to write programs with a compiler and it fixes the errors in the program before the customers get it.

Why: Level 0. No creditworthy point: 'easier to write programs' is not linked to the output, the translation each run or the customer, and 'fixes the errors' is a misconception, as the mark scheme's guidance says a compiler only reports errors at the end of translation.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.