Edexcel GCSE Computer Science (1CP2) Exam Questions

• A To store data and programs permanently (1)
• The only correct answer is A. The correct answer is to store data and programs permanently.
• B is not correct because storing the data and instructions currently in use is the role of primary storage/RAM, which is volatile, not the role of secondary storage
• C is not correct because calculations on data are carried out by the CPU, not by secondary storage
• D is not correct because secondary storage is not directly accessible by the CPU; data must first be copied into RAM

Award one mark for any of the following up to a maximum of two marks:

• The program instructions and data are stored together in main memory/RAM (1)
• The same memory is used for both instructions and data (1)
• The instructions are fetched from main memory and executed by the CPU (1)
• The instructions are fetched and executed one at a time / in sequence (1)
• The program can be changed/replaced by loading new instructions into memory, without changing the hardware (1)

Do not accept the program is stored in secondary storage / on the hard disk.

Do not accept the program is stored in the CPU / in registers.

Award up to two marks for a linked description such as:

• It reads/monitors the temperature/humidity/light level using sensors (1) to switch the heaters/vents/lamps/watering system on or off when the reading is outside the set range (1)
• It compares the readings from the sensors with the set values/thresholds stored in its memory (1) to decide whether the conditions need to be changed (1)
• It monitors the light level using a light sensor (1) and turns the lamps on when the light falls below the level the plants need (1)
• It monitors the soil moisture using a soil moisture sensor (1) and turns the water pump/irrigation on when the soil is too dry (1)

For the second mark, the action/response must be linked to the sensor reading given in the first point.

Allow named sensors (temperature/humidity/light/soil moisture) and named outputs (heater, fan, vent/window, lamp, irrigation/water pump).

Do not accept answers that only name a sensor or only name an output, e.g. 'it has a temperature sensor and a heater', as there is no link between the reading and the control action.

Do not accept answers where a person switches the equipment on or off, as the embedded system controls the conditions automatically.

Award up to two marks for a linked explanation such as:

• Decodes/interprets/translates the instruction (1) to work out what the instruction is/what operation is required (1)
• Sends control signals to the other components (1) so that the correct component carries out the instruction (1), e.g. the ALU/main memory
• Controls the fetch of the instruction from main memory (1) because the address of the next instruction is sent via the address bus (1)
• Controls the fetch of the next instruction from main memory (1) by sending a control signal/read signal to main memory (1)

For both marks, the expansion must follow/associate with the statement.

For the decode point, 'decodes the instruction' alone gains 1 mark; a second mark needs the purpose of decoding, i.e. working out what the instruction is/what operation is required.

Do not accept 'it controls the CPU' on its own, without naming a task in the cycle.

Do not accept 'it fetches the instruction from memory' on its own, as this describes the fetch step rather than the control unit's role; credit only if linked to controlling/signalling the fetch.

Do not accept carrying out arithmetic/logical operations, as these are carried out by the ALU, or holding the address of the next instruction, as this is the program counter.

Do not accept storing the instruction in a register (e.g. MAR/MDR), as this is not the role of the control unit.