Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 6 marks

Pick again
Print
1Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

2Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

3Explain2 marksPacket Switching Swap Remove

Data is split into packets before it is sent across the internet.

Explain why each packet has a packet number in its header.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The receiver can put the packets back into the correct order (1) because packets may arrive out of order/take different routes (1)
  • The receiver can see if a packet is missing (1) because the sequence of numbers shows a gap (1)
  • The receiver knows when the whole file has arrived (1) because the total number of packets/last packet number is known (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'so the packets can be put back in the correct order/reassembled' for the first mark, but the second mark needs the reason, i.e. packets may arrive out of order/take different routes.

Do not accept 'so the packets can be identified' without stating what the number is used for, e.g. reordering or spotting a missing packet.

Do not accept 'so the router knows where to send it' - the router uses the destination IP address, not the packet number.

Example answers and how they were marked
Full marks2/2

The receiver can put the packets back in the correct order because they may arrive out of order.

Why: Linked point (1) and reason (1): the packet number allows reordering because packets can arrive out of order.

Some marks1/2

It shows the receiver the order of the packets.

Why: The point is given (1) but there is no linked reason, such as packets arriving out of order.

No marks0/2

So the router knows which route to use.

Why: Routers use the destination IP address, not the packet number, so this earns nothing; it is named in the mark scheme as a 'Do not accept'.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.