Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 6 marks

Pick again
Print
1Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

2Describe2 marksWireless Connections Swap Remove

A family uses a wireless network at home.

Describe how interference can affect the performance of a wireless network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Other electrical/radio devices nearby (1) interfere with the wireless signal so data is corrupted (1)
  • Interference corrupts data (1) so the data has to be resent, which increases latency/slows the transfer (1)
  • Interference reduces the strength of the signal received (1) which lowers the data transfer rate the connection can support (1)
  • Interference makes the connection drop (1) so data transfer stops/devices have to reconnect (1)

Do not accept responses that only name a device (microwave, phone) without saying how it affects the network.

Do not accept responses that only state the network becomes slower without saying what causes the interference or how it affects the data.

Do not accept responses about wired connections or cables.

Example answers and how they were marked
Full marks2/2

Other electrical devices nearby can interfere with the wireless signal and corrupt data, so the data has to be resent and transfers are slower.

Why: Linked point: other electrical devices interfere and corrupt data (1), developed by the data being resent, which slows the transfer (1).

Some marks1/2

Other electrical devices nearby can interfere with the wireless signal.

Why: Cause given: other electrical devices interfere with the signal (1), but no development of how this affects the data or performance.

No marks0/2

Interference happens when the wireless cable is damaged by other cables.

Why: Misconception about cables; the mark scheme does not accept responses about wired connections or cables.

3Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.