Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 9 marks

Pick again
Print
1Short recall1 markSecondary Memory Swap Remove

Data is stored on optical discs as pits and lands.

Name the component in an optical disc drive that reads this data.

[1 mark]
Mark scheme

Award one mark for:

  • Laser (1)

Allow laser beam

Do not accept read/write head

Do not accept pits

Do not accept lands

Do not accept reflective surface

Do not accept magnet/magnetic

Example answers and how they were marked
Full marks1/1

Laser

Why: Laser is the creditworthy answer (1).

No marks0/1

A read/write head

Why: Read/write head is not accepted by the mark scheme; it reads magnetic media, not optical discs, so no marks are awarded.

No marks0/1

Pits and lands

Why: Pits and lands are what the laser reads, not the component that reads the data, so the mark scheme does not accept them.

2Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

3Describe2 marksTranslators Swap Remove

Source code can contain syntax errors.

Describe how a compiler and an interpreter differ in the way they deal with syntax errors.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • The compiler reports all syntax errors after translation has finished (1) whereas the interpreter stops at the first error it finds (1)
  • The interpreter reports a syntax error as soon as it finds one (1) and does not translate/execute any more of the program (1)
  • The compiler continues translating after an error (1) and reports the errors at the end (1)
  • The interpreter stops translating when it reaches an error (1) but the compiler finishes translating before reporting errors (1)

Do not accept answers about fixing/correcting errors or about object code.

Do not award 'the compiler finds more errors' without saying errors are reported at the end.

Example answers and how they were marked
Full marks2/2

A compiler reports all the syntax errors at the end of translation, whereas an interpreter stops and reports the error as soon as it finds one.

Why: Compiler reports errors at the end (1) and interpreter stops/reports at the first error (1).

Some marks1/2

An interpreter stops translating when it finds a syntax error.

Why: Interpreter stops at the first error (1); no comparison with when the compiler reports errors.

No marks0/2

A compiler reports a syntax error immediately, before translating the rest of the program.

Why: Reverses the compiler's behaviour; it finishes translating before reporting errors.

4Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

5Calculate2 marksBinary Shifts Swap Remove

Computers manipulate binary patterns.

Complete the table with the result of applying the shift to the binary pattern.

[2 marks]
Binary patternShift8-bit binary result
1000 0001Logical shift right by 1
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 0100 (1)
  • 0000 (1)

0 marks if the response is not 8-bit binary.

Example answers and how they were marked
Full marks2/2

0100 0000

Why: Every bit moves 1 place right, with 0s in from the left: both nibbles are correct (2).

Some marks1/2

0100 0001

Why: A slip in the last bit. The first nibble is correct (1); the second is not.

No marks0/2

0000 0010

Why: Shifts the bits the wrong way. Neither nibble is correct.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.