Edexcel GCSE Computer Science (1CP2) Exam Questions

Award one mark for any of the following up to a maximum of two marks:

• Hard disk drive/HDD (1)
• External/portable hard disk drive (1)
• Magnetic tape drive (1)
• Magnetic tape (1)

Allow a named device or the storage media type, e.g. hard disk/hard disc for hard disk drive, tape for magnetic tape

Allow floppy disk/floppy disk drive

Do not accept solid state devices (SSD, USB flash drive/memory stick, SD card/memory card) or optical media (CD/DVD/Blu-ray) as these do not store data using magnetism

Award up to two marks for a linked explanation such as:

• A temperature sensor measures/reads the temperature in the greenhouse (1) which the processor compares with the value stored in the system (1)
• The heater is switched on (1) when the temperature reading goes below the value stored in the system (1)
• A fan/vent/window is opened/a cooler is switched on (1) when the temperature reading goes above the value stored in the system (1)
• The temperature is checked/measured continuously (1) so the heater/fan is switched on or off as soon as the temperature changes (1)

For both marks, the expansion must follow/associate with the statement.

Allow one mark for a correct point on its own without a linked reason, e.g. 'a temperature sensor measures the temperature'.

Do not award 'the embedded system controls/keeps the temperature correct' as this repeats the question.

Do not accept naming a device without saying what it does, e.g. 'the greenhouse has a thermostat'.

Indicative content

Why secondary storage is needed

• Secondary storage is non-volatile, so it keeps the operating system, applications and students' work when the power is turned off.
• It stores programs and files that are not currently in use, so they are not lost when the computer is switched off.
• It provides a larger capacity than primary storage for files such as students' work, videos and photographs.
• It allows each computer to keep many students' files and the software the school has installed.

The difference between primary and secondary storage

• Primary storage (RAM) is volatile and directly accessible by the CPU; secondary storage is non-volatile and not directly accessible by the CPU.
• RAM holds the data and instructions currently in use; secondary storage holds data and programs long term.
• Primary storage is faster but smaller and more expensive per gigabyte; secondary storage is slower but larger and cheaper.
• The school's computers need both: RAM to run the operating system and applications, and secondary storage to keep them when the computer is switched off.

A suitable type of secondary storage for the school's computers and a reason why it is suitable

• A solid state drive (SSD) is suitable because it has no moving parts, so it is durable and quiet, and has fast read/write speeds, which helps the computers start up quickly.
• A magnetic hard disk drive (HDD) is suitable because it is cheap and offers a very large capacity, which is useful for storing many students' files.
• Either type could be used; a small SSD for the operating system and applications plus a large HDD for files would balance speed and cost.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Additional guidance

• Award credit for a type of secondary storage only when a reason is given that is linked to the school's computers; a named type alone (e.g. 'SSD') is not creditworthy. Do not accept RAM as secondary storage or the claim that secondary storage is the same as RAM. Do not accept CD/DVD/Blu-ray as the main storage for the school's computers because their capacity is too low and write speeds are slow.
• For Level 3, the answer must cover all three bullets and apply at least one point to the school's computers. A 6-mark answer is well developed with sustained reasoning and a justified choice; a 5-mark answer covers all three but with limited development or application. Comparisons of speed and cost between primary and secondary storage are creditworthy as part of the difference.

Indicative content

Fetching and decoding an instruction

• The register that holds the address of the next instruction (the program counter) contains the address of the instruction to be fetched.
• This address is sent to main memory (RAM) and the instruction is copied from main memory into a register inside the CPU.
• The program counter is updated so that it holds the address of the next instruction in the program.
• The control unit decodes the instruction that has been fetched, working out which operation is required and which data or registers are needed.
• The control unit sends control signals to coordinate the other components as the instruction is carried out.
• The control unit decides what happens next, for example after a comparison it decides whether the next instruction is the following one or a jump.

The arithmetic logic unit (ALU) executes an instruction

• The control unit directs the arithmetic logic unit (ALU) to carry out the operation.
• The ALU performs arithmetic operations such as addition, subtraction, multiplication and division, for example adding two values in a program written by the class.
• The ALU performs logical operations such as comparing two values to see if they are equal or whether one is greater than the other.
• The result of the operation carried out by the ALU is passed back and stored in a register.
• The ALU operates on data that has been fetched from main memory; it does not fetch the instruction and it does not decide which instruction is next.

Registers

• Registers are small, very fast memory locations inside the CPU.
• They hold the data, addresses and results that the CPU is working on during the cycle.
• Registers are used in every stage of the cycle, not only when the ALU produces a result.
• Because registers are inside the CPU they can be read and written much faster than main memory during the cycle.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)
• A Level 3 answer must link the roles of all three components to the fetch, decode and execute stages. An answer that links only one component to a stage, with the other points listed separately, is Level 1 (1–2 marks); an answer that links two of the components to stages is Level 2 (3–4 marks). A point repeated under more than one heading is credited once only.
• Accept 'the program counter', 'the address register' or 'a register holding the address of the next instruction' as the register that holds the address of the next instruction. Do not accept 'the control unit performs the calculations', 'the ALU controls the timing of the CPU' / 'the ALU sends the clock signal' or 'registers are in main memory (RAM)'.