Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Multiple choice1 markProtocols & Layers Swap Remove

Data is sent over a network using the TCP/IP model.

Identify the protocol that reassembles the packets at the destination.

[1 mark]
  • AFTP
  • BHTTP
  • CIP
  • DTCP
Mark scheme
  • D TCP (1)
  • The only correct answer is D. The correct answer is TCP.
  • A is not correct because FTP is used to transfer files
  • B is not correct because HTTP is used to request web pages
  • C is not correct because IP routes packets but does not reassemble them
Example answers and how they were marked
Full marks1/1

D TCP

Why: TCP reassembles the packets at the destination (1).

No marks0/1

C IP

Why: IP routes packets but does not reassemble them (0).

No marks0/1

B HTTP

Why: HTTP is used to request web pages, not to reassemble packets (0).

2Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

3Explain2 marksAddressing Swap Remove

The internet is moving from IPv4 addresses to IPv6 addresses.

Explain why IPv6 addresses are needed.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • IPv4 addresses are 32-bit (1) so there are only about 4 billion of them/not enough for every device (1)
  • More devices are connecting to the internet than IPv4 can address (1) so a larger range of addresses is needed (1)
  • IPv6 uses 128-bit addresses (1) so far more devices can be given an address (1)

For both marks, the expansion must follow/associate with the statement.

Do not accept 'IPv6 is newer/better/faster/more secure' without a link to the number of addresses available.

Example answers and how they were marked
Full marks2/2

IPv4 addresses are only 32 bits long, so there are not enough of them for all the devices that now connect to the internet.

Why: Point that IPv4 addresses are 32-bit (1) and linked reason that this limits the number of addresses below the number of devices (1).

Some marks1/2

Because we have run out of IPv4 addresses.

Why: A valid point (1) but no linked reason about why IPv4 addresses are limited, such as the 32-bit size or the number of devices.

No marks0/2

Because IPv6 is newer and more secure than IPv4.

Why: No link to the number of addresses available; the mark scheme says not to accept newer/better/more secure on its own.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.