Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Multiple choice1 markPacket Switching Swap Remove

A computer sends an email to a server on another network.

Identify the information in a packet header that a router uses to decide where to send the packet.

[1 mark]
  • ADestination IP address
  • BMAC address
  • CPacket number
  • DSource IP address
Mark scheme
  • A Destination IP address (1)
  • The only correct answer is A. A router reads the destination IP address in a packet header to forward the packet towards its destination.
  • B is not correct because a MAC address identifies a device on a local network and is not used to route packets across the internet
  • C is not correct because the packet number is used at the destination to put the packets back into the correct order
  • D is not correct because the source IP address shows where the packet came from, not where it is going
Example answers and how they were marked
Full marks1/1

A Destination IP address

Why: Selected the destination IP address, the header information a router reads to forward the packet (1).

No marks0/1

D Source IP address

Why: A near miss: the source address is in the header, but it shows where the packet came from, so it is not used to decide where the packet is sent.

No marks0/1

B MAC address

Why: Typical misconception reported by examiners: a MAC address identifies a device on a local network and is not used to route packets across the internet.

2Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

3Describe2 marksWired Connections Swap Remove

A farm uses wired connections to link sensors in its fields to a computer in the farmhouse.

Describe how the range of a wired connection can affect the performance of this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • (Twisted pair/copper) cable only carries data over a limited distance (about 100 metres) (1) so sensors further away need another switch/device to pass the data on to the farmhouse (1)
  • Fibre optic cable can carry data over much longer distances (1) so wired connections can reach sensors across the whole farm (1)
  • Data sent further than the cable's range is not received (1) so the computer in the farmhouse does not get readings from those sensors (1)
  • A wireless connection can reach sensors that are out of range of the cables (1) so a mix of the two can give readings across the whole site (1)

Allow responses about signal weakening/being lost over a long cable.

Do not accept responses about bandwidth or speed, as range is about distance, not the amount or rate of data.

Example answers and how they were marked
Full marks2/2

Twisted pair copper cable only carries data for about 100 metres so a switch is needed in each field to pass the readings on to the farmhouse.

Why: Point that copper cable has a limited distance (1) linked to needing another device to extend the network (1).

Some marks1/2

Fibre optic cable can carry data much further than copper cable.

Why: Gives the first point of a linked pair (1) but does not develop it to say what this allows the farm to do.

No marks0/2

A longer cable gives the network a bigger bandwidth so the sensors work faster.

Why: About bandwidth and speed rather than range, which the mark scheme says is not accepted.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.