Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 659 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

An IPv4 address is made up of four 8-bit numbers separated by dots.

State the range of values that each number in an IPv4 address can have.

[1 mark]
Mark scheme

Award one mark for:

  • 0 to 255 (1)

Allow 0–255 / 0-255 / between 0 and 255 / 0 and 255.

Do not accept 1 to 255 (0 is a valid value).

Do not accept any range that includes 256, e.g. 0 to 256.

Example answers and how they were marked
Full marks1/1

0 to 255

Why: Gives the correct range (1).

No marks0/1

1 to 255

Why: Near miss: excludes 0, which is a valid value; the Do not accept line applies.

No marks0/1

0 to 256

Why: Includes 256, which is not valid; the Do not accept line applies.

2Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

3Explain2 marksWireless Connections Swap Remove

A wireless access point has a limited bandwidth.

Explain why connecting more devices to the access point can reduce the speed each device gets.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • (All) devices share the bandwidth of the access point (1) so each device gets a smaller share, which reduces its speed/slows down transfers (1)
  • Bandwidth is the maximum amount of data that can be transferred at one time (1) so when devices send more data than this, the data must wait/queue, which slows down transfers (1)
  • (Many) devices send data at the same time (1) so the devices take turns, which reduces the amount of data each one can send/the speed each device gets (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'connection speed'/'download speed' for speed.

Do not accept 'the signal is shared' without saying that this reduces the bandwidth/data each device can send.

Do not accept the idea that adding devices increases the bandwidth.

Example answers and how they were marked
Full marks2/2

All the devices share the access point's bandwidth, so each device gets less bandwidth and its downloads take longer.

Why: Linked point (1): bandwidth is shared; reason (1): each device gets a smaller share, which reduces its speed/slows transfers.

Some marks1/2

The bandwidth is shared between all the devices.

Why: Point only (1): the bandwidth is shared. No linked reason about each device getting less bandwidth or a reduced speed.

No marks0/2

Adding more devices increases the bandwidth, so the network can send more data.

Why: Misconception that adding devices increases bandwidth; the mark scheme says not to accept this.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 65
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 12 questions

5.3 Cybersecurity

Malware 8 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.