Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

An IPv4 address is made up of four 8-bit numbers separated by dots.

State the range of values that each number in an IPv4 address can have.

[1 mark]
Mark scheme

Award one mark for:

  • 0 to 255 (1)

Allow 0–255 / 0-255 / between 0 and 255 / 0 and 255.

Do not accept 1 to 255 (0 is a valid value).

Do not accept any range that includes 256, e.g. 0 to 256.

Example answers and how they were marked
Full marks1/1

0 to 255

Why: Gives the correct range (1).

No marks0/1

1 to 255

Why: Near miss: excludes 0, which is a valid value; the Do not accept line applies.

No marks0/1

0 to 256

Why: Includes 256, which is not valid; the Do not accept line applies.

2Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

3Describe2 marksWireless Connections Swap Remove

A family uses a wireless network at home.

Describe how interference can affect the performance of a wireless network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Other electrical/radio devices nearby (1) interfere with the wireless signal so data is corrupted (1)
  • Interference corrupts data (1) so the data has to be resent, which increases latency/slows the transfer (1)
  • Interference reduces the strength of the signal received (1) which lowers the data transfer rate the connection can support (1)
  • Interference makes the connection drop (1) so data transfer stops/devices have to reconnect (1)

Do not accept responses that only name a device (microwave, phone) without saying how it affects the network.

Do not accept responses that only state the network becomes slower without saying what causes the interference or how it affects the data.

Do not accept responses about wired connections or cables.

Example answers and how they were marked
Full marks2/2

Other electrical devices nearby can interfere with the wireless signal and corrupt data, so the data has to be resent and transfers are slower.

Why: Linked point: other electrical devices interfere and corrupt data (1), developed by the data being resent, which slows the transfer (1).

Some marks1/2

Other electrical devices nearby can interfere with the wireless signal.

Why: Cause given: other electrical devices interfere with the signal (1), but no development of how this affects the data or performance.

No marks0/2

Interference happens when the wireless cable is damaged by other cables.

Why: Misconception about cables; the mark scheme does not accept responses about wired connections or cables.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.