Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 659 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

An IPv4 address is made up of four 8-bit numbers separated by dots.

State the range of values that each number in an IPv4 address can have.

[1 mark]
Mark scheme

Award one mark for:

  • 0 to 255 (1)

Allow 0–255 / 0-255 / between 0 and 255 / 0 and 255.

Do not accept 1 to 255 (0 is a valid value).

Do not accept any range that includes 256, e.g. 0 to 256.

Example answers and how they were marked
Full marks1/1

0 to 255

Why: Gives the correct range (1).

No marks0/1

1 to 255

Why: Near miss: excludes 0, which is a valid value; the Do not accept line applies.

No marks0/1

0 to 256

Why: Includes 256, which is not valid; the Do not accept line applies.

2Describe2 marksWired Connections Swap Remove

A hospital connects the computers on a ward using wired connections.

Describe how using wired connections can reduce latency on this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Data travels along the cable directly to the switch on a single continuous path (1) so the time between sending and receiving the data is short (1)
  • A cable is not affected by interference from other devices/wireless traffic nearby (1) so packets are not lost and resent, which would add to the delay (1)
  • The switch sends the data only to the port of the correct device, not to every device (1) so the data spends less time travelling and the delay is lower (1)
  • Fewer devices share a cable than share a wireless channel (1) so packets do not queue/wait before they are sent (1)

The first mark is for the way the wired connection carries the data; the second mark is for how this reduces the delay between sending and receiving.

Do not accept responses about bandwidth or the amount of data a cable can carry, as latency is the delay between sending and receiving.

Do not accept responses that confuse latency with speed/bandwidth, e.g. 'a wired connection is faster so there is less latency', unless they describe how the delay is reduced.

Do not accept answers that only say a wired connection is faster, with no link to the delay.

Example answers and how they were marked
Full marks2/2

The cable is not affected by interference from other devices so packets do not need to be resent and the delay stays low.

Why: First mark for the cable being free of interference (1); linked development that no packets are resent and so the delay is lower (1).

Some marks1/2

There is no interference from other devices on a cable.

Why: Gives the first point of a linked pair (1) but does not say how this reduces the delay between sending and receiving.

No marks0/2

Wired connections have a higher bandwidth so there is less latency.

Why: Confuses bandwidth with latency, which the 'Do not accept' lines rule out (0).

3Explain2 marksProtocols & Layers Swap Remove

The TCP/IP model has four layers.

Explain one function of the transport layer when a file is sent over a network.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Splits the data/file into packets (1) so each packet can be sent separately across the network (1)
  • Adds a packet/sequence number to each packet (1) so the packets can be put back into the correct order at the destination (1)
  • Detects lost/missing packets (1) so they can be requested/resent (1)
  • Creates a connection between the two computers/hosts (1) before the file is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'segments' for 'packets' (TCP divides the data into segments, which become packets at the internet layer).

Do not accept 'sends the data/file' on its own without saying what the transport layer does to the data.

Do not accept naming TCP or a port number on its own without expansion.

Do not accept routing/addressing packets using IP addresses, which is the internet layer.

Example answers and how they were marked
Full marks2/2

The transport layer splits the data into packets so each packet can be sent separately across the network.

Why: Linked point (1) and reason (1): splitting into packets lets each one be sent separately.

Some marks1/2

It splits the data into packets.

Why: Point (1) identified, but no linked reason given, so only the first mark is awarded.

No marks0/2

It routes the packets using IP addresses so they reach the right destination.

Why: Routing using IP addresses is the internet layer, not the transport layer, so no credit is given.

4Explain2 marksWireless Connections Swap Remove

An office wireless network is near a microwave oven and several other wireless networks.

Explain how interference can affect the speed of a wireless network.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The speed of data transfer is reduced/is slower (1) because interference corrupts the radio signal, so data/packets are lost and have to be resent/retransmitted (1)
  • The network speed is lower (1) because there is more noise on the wireless signal, so data is sent at a lower transmission rate (1)
  • The throughput of the wireless network is reduced (1) because time is used resending corrupted data/packets instead of sending new data (1)

For both marks, the expansion must follow/associate with the statement.

Award 1 mark for a statement that the speed/transfer rate is reduced (e.g. slower, takes longer), even if no reason is given.

Do not accept 'interference damages/corrupts the radio signal' or 'the signal is weaker' on its own without a link to the speed.

Do not accept 'data is lost' on its own without saying how this reduces the speed.

Do not accept 'interference increases the bandwidth' or 'interference makes the signal stronger'.

Example answers and how they were marked
Full marks2/2

Interference corrupts the radio signal, so packets are lost and resent, which makes the data transfer slower.

Why: Linked point (1): data transfer is slower; reason (1): interference corrupts the signal so packets are lost and resent.

Some marks1/2

The speed of the wireless network will be lower.

Why: Point only (1): states the effect on speed. No linked reason why interference causes this.

No marks0/2

Interference increases the bandwidth, so the data travels faster.

Why: Misconception that interference increases bandwidth; the mark scheme says not to accept this.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 65
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 12 questions

5.3 Cybersecurity

Malware 8 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.