Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 6 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

Routers forward data packets across the internet.

State the part of a data packet that a router uses to decide where to send it.

[1 mark]
Mark scheme

Award one mark for:

  • (Destination) IP address (1)

Allow IP address on its own (the destination is implied).

Do not accept source IP address/IP address of the sender.

Do not accept MAC address.

Do not accept domain name/web address.

Example answers and how they were marked
Full marks1/1

The destination IP address.

Why: Names the destination IP address (1).

No marks0/1

The domain name.

Why: A domain name is not used by a router to route a packet; it must be translated to an IP address first, so no mark.

No marks0/1

The MAC address.

Why: A MAC address is not used to route packets across the internet; the Do not accept line applies.

2Short recall1 markWireless Connections Swap Remove

A wireless network has a fixed amount of bandwidth.

State what happens to the bandwidth available to each device as more devices connect to the network.

[1 mark]
Mark scheme

Award one mark for:

  • It is shared between more devices, so each device gets less (bandwidth) (1)

Allow 'the bandwidth is divided/split between the devices'.

Allow 'there is less bandwidth for each device'.

Do not accept 'the speed decreases' / 'the connection slows down' on its own.

Do not accept 'the bandwidth decreases' unless it refers to the bandwidth available to each device.

Do not accept 'the bandwidth increases'.

Example answers and how they were marked
Full marks1/1

It is shared between more devices, so each device gets less bandwidth.

Why: States that the bandwidth is shared between more devices and so each device gets less (1).

No marks0/1

The speed for each device decreases.

Why: Describes speed rather than bandwidth; this near-miss is ruled out by the 'Do not accept' line.

No marks0/1

The bandwidth increases because more devices are connected.

Why: Contradicts the correct answer; bandwidth is shared between the devices, it does not increase, so no mark.

3Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

4Describe2 marksWired Connections Swap Remove

A farm uses wired connections to link sensors in its fields to a computer in the farmhouse.

Describe how the range of a wired connection can affect the performance of this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • (Twisted pair/copper) cable only carries data over a limited distance (about 100 metres) (1) so sensors further away need another switch/device to pass the data on to the farmhouse (1)
  • Fibre optic cable can carry data over much longer distances (1) so wired connections can reach sensors across the whole farm (1)
  • Data sent further than the cable's range is not received (1) so the computer in the farmhouse does not get readings from those sensors (1)
  • A wireless connection can reach sensors that are out of range of the cables (1) so a mix of the two can give readings across the whole site (1)

Allow responses about signal weakening/being lost over a long cable.

Do not accept responses about bandwidth or speed, as range is about distance, not the amount or rate of data.

Example answers and how they were marked
Full marks2/2

Twisted pair copper cable only carries data for about 100 metres so a switch is needed in each field to pass the readings on to the farmhouse.

Why: Point that copper cable has a limited distance (1) linked to needing another device to extend the network (1).

Some marks1/2

Fibre optic cable can carry data much further than copper cable.

Why: Gives the first point of a linked pair (1) but does not develop it to say what this allows the farm to do.

No marks0/2

A longer cable gives the network a bigger bandwidth so the sensors work faster.

Why: About bandwidth and speed rather than range, which the mark scheme says is not accepted.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.