Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 631 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

Routers forward data packets across the internet.

State the part of a data packet that a router uses to decide where to send it.

[1 mark]
Mark scheme

Award one mark for:

  • (Destination) IP address (1)

Allow IP address on its own (the destination is implied).

Do not accept source IP address/IP address of the sender.

Do not accept MAC address.

Do not accept domain name/web address.

Example answers and how they were marked
Full marks1/1

The destination IP address.

Why: Names the destination IP address (1).

No marks0/1

The domain name.

Why: A domain name is not used by a router to route a packet; it must be translated to an IP address first, so no mark.

No marks0/1

The MAC address.

Why: A MAC address is not used to route packets across the internet; the Do not accept line applies.

2Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

3Short recall2 marksWireless Connections Swap Remove

Wireless networks have a limited range.

State two factors that can reduce the range of a wireless network.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Walls/obstacles between the device and the access point (1)
  • Interference from other electrical devices/other devices/other wireless networks (1)
  • Distance from the access point (1)
  • Using a higher frequency band (e.g. 5GHz) (1)
  • Low transmit power of the access point/device (1)

Allow thick walls/furniture for walls/obstacles

Do not accept using more bandwidth

Do not accept a weaker signal without a stated cause

Example answers and how they were marked
Full marks2/2

Walls can block the signal, and moving further from the access point reduces the range.

Why: Gives walls as an obstacle (1) and distance from the access point (1).

Some marks1/2

Interference from other devices.

Why: Gives one valid factor, interference from other devices (1), but no second factor.

No marks0/2

Using more bandwidth reduces the range.

Why: Bandwidth does not reduce range; this is a near-miss listed as Do not accept, so no mark.

4Describe2 marksWired Connections Swap Remove

A hospital connects the computers on a ward using wired connections.

Describe how using wired connections can reduce latency on this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Data travels along the cable directly to the switch on a single continuous path (1) so the time between sending and receiving the data is short (1)
  • A cable is not affected by interference from other devices/wireless traffic nearby (1) so packets are not lost and resent, which would add to the delay (1)
  • The switch sends the data only to the port of the correct device, not to every device (1) so the data spends less time travelling and the delay is lower (1)
  • Fewer devices share a cable than share a wireless channel (1) so packets do not queue/wait before they are sent (1)

The first mark is for the way the wired connection carries the data; the second mark is for how this reduces the delay between sending and receiving.

Do not accept responses about bandwidth or the amount of data a cable can carry, as latency is the delay between sending and receiving.

Do not accept responses that confuse latency with speed/bandwidth, e.g. 'a wired connection is faster so there is less latency', unless they describe how the delay is reduced.

Do not accept answers that only say a wired connection is faster, with no link to the delay.

Example answers and how they were marked
Full marks2/2

The cable is not affected by interference from other devices so packets do not need to be resent and the delay stays low.

Why: First mark for the cable being free of interference (1); linked development that no packets are resent and so the delay is lower (1).

Some marks1/2

There is no interference from other devices on a cable.

Why: Gives the first point of a linked pair (1) but does not say how this reduces the delay between sending and receiving.

No marks0/2

Wired connections have a higher bandwidth so there is less latency.

Why: Confuses bandwidth with latency, which the 'Do not accept' lines rule out (0).

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 45
Data Protection Act 17 questions Impact of AI 16 questions Intellectual Property 12 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.