Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 6 marks

Pick again
Print
1Short recall1 markAddressing Swap Remove

Routers forward data packets across the internet.

State the part of a data packet that a router uses to decide where to send it.

[1 mark]
Mark scheme

Award one mark for:

  • (Destination) IP address (1)

Allow IP address on its own (the destination is implied).

Do not accept source IP address/IP address of the sender.

Do not accept MAC address.

Do not accept domain name/web address.

Example answers and how they were marked
Full marks1/1

The destination IP address.

Why: Names the destination IP address (1).

No marks0/1

The domain name.

Why: A domain name is not used by a router to route a packet; it must be translated to an IP address first, so no mark.

No marks0/1

The MAC address.

Why: A MAC address is not used to route packets across the internet; the Do not accept line applies.

2Short recall1 markWired Connections Swap Remove

Wired connections have characteristics that affect network performance.

State what is meant by the range of a wired network connection.

[1 mark]
Mark scheme

Award one mark for:

  • The maximum distance data/a signal can be transmitted before it becomes too weak to be received (1)

Allow 'how far a signal can travel'.

Do not accept the number of devices that can be connected to the network.

Do not accept the speed at which data is transmitted.

Do not accept bandwidth/the maximum capacity of a channel.

Do not accept latency/the delay between a signal being sent and received.

Example answers and how they were marked
Full marks1/1

The maximum distance a signal can be transmitted before it becomes too weak to be received.

Why: Gives the maximum distance a signal can be transmitted before it becomes too weak, which is the creditworthy point (1).

No marks0/1

The maximum capacity of the connection.

Why: This describes bandwidth, which the mark scheme says not to accept for range, so no mark.

No marks0/1

The delay between a signal being sent and received.

Why: This describes latency/delay, which the mark scheme says not to accept for range, so no mark.

3Describe2 marksWired Connections Swap Remove

A farm uses wired connections to link sensors in its fields to a computer in the farmhouse.

Describe how the range of a wired connection can affect the performance of this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • (Twisted pair/copper) cable only carries data over a limited distance (about 100 metres) (1) so sensors further away need another switch/device to pass the data on to the farmhouse (1)
  • Fibre optic cable can carry data over much longer distances (1) so wired connections can reach sensors across the whole farm (1)
  • Data sent further than the cable's range is not received (1) so the computer in the farmhouse does not get readings from those sensors (1)
  • A wireless connection can reach sensors that are out of range of the cables (1) so a mix of the two can give readings across the whole site (1)

Allow responses about signal weakening/being lost over a long cable.

Do not accept responses about bandwidth or speed, as range is about distance, not the amount or rate of data.

Example answers and how they were marked
Full marks2/2

Twisted pair copper cable only carries data for about 100 metres so a switch is needed in each field to pass the readings on to the farmhouse.

Why: Point that copper cable has a limited distance (1) linked to needing another device to extend the network (1).

Some marks1/2

Fibre optic cable can carry data much further than copper cable.

Why: Gives the first point of a linked pair (1) but does not develop it to say what this allows the farm to do.

No marks0/2

A longer cable gives the network a bigger bandwidth so the sensors work faster.

Why: About bandwidth and speed rather than range, which the mark scheme says is not accepted.

4Describe2 marksAddressing Swap Remove

Devices on a network use IP addresses.

Describe the purpose of an IP address.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Identifies a device on a network (1) so data can be sent to the correct device (1)
  • Gives a device a unique address (1) so packets can be routed to it across the internet (1)
  • Identifies a device on the internet (1) so it can send/receive data to/from other devices (1)

Allow 'unique' only where it is linked to identifying the device or to routing data; 'unique' on its own is not creditworthy.

Do not accept answers that only say it connects a device to the internet.

Do not accept a MAC address as the purpose of an IP address.

Do not accept domain names/web addresses (e.g. google.co.uk) as an IP address.

Example answers and how they were marked
Full marks2/2

An IP address uniquely identifies a device on a network so that data packets can be delivered to the correct destination.

Why: Linked point (1): identifies a device on a network; development (1): so data can be sent to the correct device.

Some marks1/2

It identifies a device on a network.

Why: Point only (1): identifies a device on a network; no linked development.

No marks0/2

It is a website address, such as google.co.uk, that the browser uses to find a web page.

Why: No creditworthy point: gives a domain name/web address, which the mark scheme says not to accept as an IP address.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.