Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

5 questions · 9 marks

Pick again
Print
1Short recall1 markPrimary Memory Swap Remove

Computers use RAM to store the data and instructions that are in use.

Name the term used to describe memory that loses its contents when the power is switched off.

[1 mark]
Mark scheme

Award one mark for:

  • Volatile (1)

Allow volatile memory / it is volatile.

Do not accept non-volatile, ROM, RAM or temporary/short term memory on their own, as these are not the term asked for.

Example answers and how they were marked
Full marks1/1

Volatile

Why: Correct term for memory that loses its contents when the power is switched off (1).

No marks0/1

Temporary memory

Why: Describes what such memory does but is not the term asked for; 'temporary memory' is on the Do not accept line, so no mark.

No marks0/1

Non-volatile

Why: Non-volatile memory keeps its contents when the power is switched off, the opposite of what the question describes; it is explicitly not accepted.

2Short recall2 marksSecondary Memory Swap Remove

Computers have both primary storage and secondary storage.

Define the term secondary storage.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • (Storage that is) non-volatile / keeps its data when the power is turned off (1)
  • (Storage that is) used to store programs and data/files (for later use) (1)
  • (Storage that is) not directly accessible by the CPU / not directly accessed by the CPU (1)

Allow both the non-volatile point and the stores programs and data point from one sentence if each idea is clearly stated, e.g. 'non-volatile storage that holds programs and data'.

Allow accessed via the CPU / must be copied into RAM before the CPU can use it for the third point.

Do not accept volatile / loses its data when the power is turned off.

Do not accept a description of primary storage, such as RAM or ROM.

Do not accept capacity.

Do not accept an example device on its own (e.g. hard disk drive).

Example answers and how they were marked
Full marks2/2

Secondary storage is non-volatile, so it does not lose data when the power is turned off. It is used to store programs and data files for later use.

Why: Non-volatile / keeps data when the power is off (1) and used to store programs and data files (1), each idea clearly stated.

Some marks1/2

Secondary storage is used to store programs and data files.

Why: Stores programs and data/files (1), but nothing is said about it being non-volatile or not directly accessible by the CPU.

No marks0/2

Secondary storage is volatile memory that holds the data the CPU is using at the moment.

Why: Describes primary storage (RAM) and says it is volatile, which the mark scheme says not to accept, so no marks are awarded.

3Describe2 marksStored Program Computers Swap Remove

A computer is based on the von Neumann stored program concept.

Describe how the CPU uses main memory (RAM) during the fetch-decode-execute cycle.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
  • The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
  • The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
  • The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Example answers and how they were marked
Full marks2/2

The program's instructions and the data it uses are both held in the same main memory (RAM) (1), so the CPU can fetch the instructions and the data it needs from that one memory (1).

Why: Linked point (1) that instructions and data are stored together in main memory, with the development (1) that the CPU fetches both from the same memory.

Some marks1/2

The CPU fetches the instructions from main memory (1) so that they are processed more quickly (1).

Why: The first point earns (1) for the CPU fetching instructions from main memory. The second statement is a benefit (speed), which the 'Do not accept benefits' line rules out, so it earns nothing.

No marks0/2

The control unit decodes each instruction (1) and the ALU carries out the calculations (1).

Why: Both statements name CPU components without saying what is stored, fetched or written, which the mark scheme tells examiners not to accept, so neither earns a mark.

4Explain2 marksEmbedded Systems Swap Remove

An engine control unit (ECU) in a car is an embedded system.

Explain one benefit of using an embedded system for the engine control unit instead of a general purpose computer.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • (The ECU) is more reliable/less likely to crash (1) because it only runs the one program/has a single purpose (1)
  • (The ECU) cannot be affected by other software/viruses (1) because it cannot run other software/it can only run the program it was made for (1)
  • (The ECU) is cheaper (1) because it has limited processing resources/less memory/simple components (1)
  • (The ECU) uses less power (1) because it has limited processing resources/a simpler processor (1)
  • (The ECU) is smaller (1) because it has fewer components/less memory than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

A suitable benefit stated on its own earns one mark.

Do not accept a description or a location given as the reason, e.g. 'because it is part of the car', 'because it is inside the engine', 'because it is embedded'.

Do not accept a description of an embedded system on its own as the benefit, e.g. 'it does one specific job' or 'it is part of the car'.

Do not accept 'it is faster'/'it has a more powerful processor' as embedded systems have limited processing resources.

Example answers and how they were marked
Full marks2/2

It is more reliable than a general purpose computer (1) because it only runs the one program so it will not crash and stop the engine working (1).

Why: Benefit stated (1) with a linked reason (1); the reason shows why only running one program makes it reliable.

Some marks1/2

It is more reliable (1) because it is part of the car's engine (1).

Why: Only the benefit earns a mark (1); being part of the car is a location, not a linked reason why it is reliable.

No marks0/2

It is faster than a general purpose computer (0) because it is embedded in the engine (0).

Why: Misconception that an embedded system is faster; embedded systems have limited processing resources, so neither point nor reason is creditworthy.

5Explain2 marksFetch Decode Execute Cycle Swap Remove

The von Neumann architecture is used in most computers.

Explain one feature of the von Neumann stored program concept.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The instructions/program instructions and data are stored together in main memory/RAM (1) so the CPU can fetch each instruction (from its address) and execute it (1)
  • The instructions/program instructions are held in main memory/RAM (1) rather than being built into/part of the hardware, so the computer does not need to be rewired/rebuilt to run a different program (1)
  • The next instruction to be executed/instruction is held in main memory/RAM (1) so the CPU can fetch it using its address before it is decoded and executed (1)

For both marks, the expansion must follow/associate with the statement.

A point/statement on its own can only earn one mark.

Do not accept a response that only refers to data being stored in main memory/RAM without referring to the instructions/program instructions.

Do not accept instructions/programs being stored on the hard disk/backing store.

Do not accept 'the program is stored in memory' without saying that it is the instructions/program instructions that are stored there.

Example answers and how they were marked
Full marks2/2

Both the instructions of the program and the data it uses are stored together in the same main memory, so the CPU can fetch each instruction in turn and execute it.

Why: Linked point (1) and reason (1).

Some marks1/2

The instructions of the program are stored in main memory.

Why: Point only (1); no linked reason about fetching/executing the instructions.

No marks0/2

The program is stored on the hard disk and is copied into the CPU when it is run.

Why: Misconception covered by the 'Do not accept' line: the instructions must be stored in main memory/RAM, not on the hard disk/backing store, for the CPU to fetch them.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.