Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Short recall1 markPrimary Memory Swap Remove

Computers use RAM to store the data and instructions that are in use.

Name the term used to describe memory that loses its contents when the power is switched off.

[1 mark]
Mark scheme

Award one mark for:

  • Volatile (1)

Allow volatile memory / it is volatile.

Do not accept non-volatile, ROM, RAM or temporary/short term memory on their own, as these are not the term asked for.

Example answers and how they were marked
Full marks1/1

Volatile

Why: Correct term for memory that loses its contents when the power is switched off (1).

No marks0/1

Temporary memory

Why: Describes what such memory does but is not the term asked for; 'temporary memory' is on the Do not accept line, so no mark.

No marks0/1

Non-volatile

Why: Non-volatile memory keeps its contents when the power is switched off, the opposite of what the question describes; it is explicitly not accepted.

2Short recall2 marksSecondary Memory Swap Remove

Computers have both primary storage and secondary storage.

Define the term secondary storage.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • (Storage that is) non-volatile / keeps its data when the power is turned off (1)
  • (Storage that is) used to store programs and data/files (for later use) (1)
  • (Storage that is) not directly accessible by the CPU / not directly accessed by the CPU (1)

Allow both the non-volatile point and the stores programs and data point from one sentence if each idea is clearly stated, e.g. 'non-volatile storage that holds programs and data'.

Allow accessed via the CPU / must be copied into RAM before the CPU can use it for the third point.

Do not accept volatile / loses its data when the power is turned off.

Do not accept a description of primary storage, such as RAM or ROM.

Do not accept capacity.

Do not accept an example device on its own (e.g. hard disk drive).

Example answers and how they were marked
Full marks2/2

Secondary storage is non-volatile, so it does not lose data when the power is turned off. It is used to store programs and data files for later use.

Why: Non-volatile / keeps data when the power is off (1) and used to store programs and data files (1), each idea clearly stated.

Some marks1/2

Secondary storage is used to store programs and data files.

Why: Stores programs and data/files (1), but nothing is said about it being non-volatile or not directly accessible by the CPU.

No marks0/2

Secondary storage is volatile memory that holds the data the CPU is using at the moment.

Why: Describes primary storage (RAM) and says it is volatile, which the mark scheme says not to accept, so no marks are awarded.

3Describe2 marksFetch Decode Execute Cycle Swap Remove

The control unit is one component of the CPU.

Describe the role of the control unit in the fetch-decode-execute cycle.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Decodes instructions (1) to determine what action/operation is required (1)
  • Sends control signals (1) along the control bus to coordinate/control the actions of other components (1)
  • Controls the fetch stage (1) by causing the next instruction to be fetched from main memory/RAM (1)
  • Controls the execute stage (1) by telling the ALU/other components when to carry out the required operation (1)

Do not accept responses relating to how the control unit affects performance, such as increasing clock speed.

Do not accept responses that describe the role of the ALU, registers or clock instead of the control unit.

Do not accept responses about the ALU performing calculations unless the control unit controlling the ALU is also stated.

Example answers and how they were marked
Full marks2/2

The control unit decodes instructions to determine what action is required.

Why: Linked point (1) and development (1): decodes instructions and determines the required action.

Some marks1/2

The control unit controls the fetch stage of the cycle.

Why: Point only (1): controls the fetch stage, but no linked development.

No marks0/2

The control unit carries out arithmetic and logical operations on data.

Why: No creditworthy point: describes the role of the ALU, which the mark scheme rejects.

4Explain2 marksEmbedded Systems Swap Remove

An engine control unit (ECU) in a car is an embedded system.

Explain one benefit of using an embedded system for the engine control unit instead of a general purpose computer.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • (The ECU) is more reliable/less likely to crash (1) because it only runs the one program/has a single purpose (1)
  • (The ECU) cannot be affected by other software/viruses (1) because it cannot run other software/it can only run the program it was made for (1)
  • (The ECU) is cheaper (1) because it has limited processing resources/less memory/simple components (1)
  • (The ECU) uses less power (1) because it has limited processing resources/a simpler processor (1)
  • (The ECU) is smaller (1) because it has fewer components/less memory than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

A suitable benefit stated on its own earns one mark.

Do not accept a description or a location given as the reason, e.g. 'because it is part of the car', 'because it is inside the engine', 'because it is embedded'.

Do not accept a description of an embedded system on its own as the benefit, e.g. 'it does one specific job' or 'it is part of the car'.

Do not accept 'it is faster'/'it has a more powerful processor' as embedded systems have limited processing resources.

Example answers and how they were marked
Full marks2/2

It is more reliable than a general purpose computer because it only runs the one program so it will not crash and stop the engine working.

Why: Benefit stated (1) with a linked reason (1); the reason shows why only running one program makes it reliable.

Some marks1/2

It is more reliable because it is part of the car's engine.

Why: Only the benefit earns a mark (1); being part of the car is a location, not a linked reason why it is reliable.

No marks0/2

It is faster than a general purpose computer because it is embedded in the engine.

Why: Misconception that an embedded system is faster; embedded systems have limited processing resources, so neither point nor reason is creditworthy.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.