Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 659 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 7 marks

Pick again
Print
1Multiple choice1 markAddressing Swap Remove

A technician is checking the IP addresses of the devices on a network.

Identify the valid IPv4 address.

[1 mark]
  • A192.168.1
  • B192.168.1.1
  • C192.168.1.1.1
  • D192.168.1.256
Mark scheme
  • B 192.168.1.1 (1)
  • The only correct answer is B. The correct answer is 192.168.1.1.
  • A is not correct because it is an incomplete address with only three numbers, not four
  • C is not correct because it is an address with five numbers, not four
  • D is not correct because it contains 256, which is outside the range 0 to 255
Example answers and how they were marked
Full marks1/1

B 192.168.1.1

Why: Correct option (1): an IPv4 address is four numbers, each from 0 to 255, separated by dots.

No marks0/1

D 192.168.1.256

Why: Near miss: it has four numbers but 256 is outside the range 0 to 255 (mark scheme line D), so no mark.

No marks0/1

A 192.168.1

Why: It has only three numbers, so it is not a complete IPv4 address (mark scheme line A), so no mark.

2Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

3Describe2 marksWired Connections Swap Remove

A school connects its desktop computers to the network using Ethernet cables.

Describe one way that using a wired connection can give a faster transfer of data than a wireless connection.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • (Ethernet) cables are not affected by interference from other devices (1) so data is transferred at a consistent/steady speed (1)
  • Each device has its own cable to the switch (1) so the full bandwidth is available to that device and speeds do not drop as more users join (1)
  • Fibre optic cable has a higher bandwidth than a wireless link (1) so more data can be sent along the cable each second (1)
  • The cable gives a direct/physical path to the switch (1) so data is less likely to be lost and resent, which would slow the transfer (1)

Do not accept responses about security, reliability or users being unable to move around, as these are not about speed.

Do not accept answers that only say a wired/cable connection is faster, or that fibre is faster, without saying why.

Example answers and how they were marked
Full marks2/2

The cable is not affected by interference from other devices such as other networks or microwaves so the data is sent at a steady speed instead of slowing down.

Why: Point that the cable is not affected by interference (1) linked to a consistent data transfer speed (1).

Some marks1/2

Ethernet cables are not affected by interference.

Why: Gives the first point of a linked pair (1) but does not develop it to say how this makes the transfer faster.

No marks0/2

A wired connection is faster because the data travels down a cable and not through the air.

Why: Repeats the question (wired is faster) with no reason, which the mark scheme's final line says is not accepted.

4Describe2 marksWired Connections Swap Remove

A farm uses wired connections to link sensors in its fields to a computer in the farmhouse.

Describe how the range of a wired connection can affect the performance of this network.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • (Twisted pair/copper) cable only carries data over a limited distance (about 100 metres) (1) so sensors further away need another switch/device to pass the data on to the farmhouse (1)
  • Fibre optic cable can carry data over much longer distances (1) so wired connections can reach sensors across the whole farm (1)
  • Data sent further than the cable's range is not received (1) so the computer in the farmhouse does not get readings from those sensors (1)
  • A wireless connection can reach sensors that are out of range of the cables (1) so a mix of the two can give readings across the whole site (1)

Allow responses about signal weakening/being lost over a long cable.

Do not accept responses about bandwidth or speed, as range is about distance, not the amount or rate of data.

Example answers and how they were marked
Full marks2/2

Twisted pair copper cable only carries data for about 100 metres so a switch is needed in each field to pass the readings on to the farmhouse.

Why: Point that copper cable has a limited distance (1) linked to needing another device to extend the network (1).

Some marks1/2

Fibre optic cable can carry data much further than copper cable.

Why: Gives the first point of a linked pair (1) but does not develop it to say what this allows the farm to do.

No marks0/2

A longer cable gives the network a bigger bandwidth so the sensors work faster.

Why: About bandwidth and speed rather than range, which the mark scheme says is not accepted.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 65
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 12 questions

5.3 Cybersecurity

Malware 8 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.