Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Multiple choice1 markAddressing Swap Remove

A technician is checking the IP addresses of the devices on a network.

Identify the valid IPv4 address.

[1 mark]
  • A192.168.1
  • B192.168.1.1
  • C192.168.1.1.1
  • D192.168.1.256
Mark scheme
  • B 192.168.1.1 (1)
  • The only correct answer is B. The correct answer is 192.168.1.1.
  • A is not correct because it is an incomplete address with only three numbers, not four
  • C is not correct because it is an address with five numbers, not four
  • D is not correct because it contains 256, which is outside the range 0 to 255
Example answers and how they were marked
Full marks1/1

B 192.168.1.1

Why: Correct option (1): an IPv4 address is four numbers, each from 0 to 255, separated by dots.

No marks0/1

D 192.168.1.256

Why: Near miss: it has four numbers but 256 is outside the range 0 to 255 (mark scheme line D), so no mark.

No marks0/1

A 192.168.1

Why: It has only three numbers, so it is not a complete IPv4 address (mark scheme line A), so no mark.

2Short recall2 marksWireless Connections Swap Remove

Wireless connections use radio waves.

Give two reasons why a wireless connection can have a lower speed than a wired connection.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Interference from other electrical/electronic devices (1)
  • Walls/obstacles block or weaken the signal (1)
  • The signal gets weaker the further a device is from the access point (1)
  • Other devices/networks use the same wireless channel/frequency (1)
  • A wireless channel has less bandwidth than a wired connection (1)

Do not accept 'higher latency', because latency is a delay and does not reduce the speed at which data is transferred.

Do not accept 'wireless is slower' / 'wired is faster' without a reason.

Do not accept 'radio waves are slower than signals in a cable' as they travel at the same speed.

Example answers and how they were marked
Full marks2/2

Other electrical devices can cause interference, and walls can block the signal.

Why: Gives interference (1) and walls blocking the signal (1).

Some marks1/2

Walls can block the wireless signal.

Why: Gives one valid reason, walls blocking the signal (1), but no second reason.

No marks0/2

Wireless is slower because it has a higher latency, so the data takes longer to arrive.

Why: Confuses latency (a delay) with speed; 'higher latency' is not accepted and no other creditworthy reason is given.

3Explain2 marksPacket Switching Swap Remove

Data is split into packets before it is sent across the internet.

Explain why each packet has a packet number in its header.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The receiver can put the packets back into the correct order (1) because packets may arrive out of order/take different routes (1)
  • The receiver can see if a packet is missing (1) because the sequence of numbers shows a gap (1)
  • The receiver knows when the whole file has arrived (1) because the total number of packets/last packet number is known (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'so the packets can be put back in the correct order/reassembled' for the first mark, but the second mark needs the reason, i.e. packets may arrive out of order/take different routes.

Do not accept 'so the packets can be identified' without stating what the number is used for, e.g. reordering or spotting a missing packet.

Do not accept 'so the router knows where to send it' - the router uses the destination IP address, not the packet number.

Example answers and how they were marked
Full marks2/2

The receiver can put the packets back in the correct order because they may arrive out of order.

Why: Linked point (1) and reason (1): the packet number allows reordering because packets can arrive out of order.

Some marks1/2

It shows the receiver the order of the packets.

Why: The point is given (1) but there is no linked reason, such as packets arriving out of order.

No marks0/2

So the router knows which route to use.

Why: Routers use the destination IP address, not the packet number, so this earns nothing; it is named in the mark scheme as a 'Do not accept'.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.