Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 693 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 5 marks

Pick again
Print
1Multiple choice1 markAddressing Swap Remove

A technician is checking the IP addresses of the devices on a network.

Identify the valid IPv4 address.

[1 mark]
  • A192.168.1
  • B192.168.1.1
  • C192.168.1.1.1
  • D192.168.1.256
Mark scheme
  • B 192.168.1.1 (1)
  • The only correct answer is B. The correct answer is 192.168.1.1.
  • A is not correct because it is an incomplete address with only three numbers, not four
  • C is not correct because it is an address with five numbers, not four
  • D is not correct because it contains 256, which is outside the range 0 to 255
Example answers and how they were marked
Full marks1/1

B 192.168.1.1

Why: Correct option (1): an IPv4 address is four numbers, each from 0 to 255, separated by dots.

No marks0/1

D 192.168.1.256

Why: Near miss: it has four numbers but 256 is outside the range 0 to 255 (mark scheme line D), so no mark.

No marks0/1

A 192.168.1

Why: It has only three numbers, so it is not a complete IPv4 address (mark scheme line A), so no mark.

2Short recall2 marksWireless Connections Swap Remove

Latency affects the performance of a network.

Define the term latency.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A delay/time/lag (1)
  • Between a signal/request being sent and a response/data being received (1)

Allow 'the time taken for data to travel from source to destination' for both marks.

Do not accept 'the speed at which data travels' / 'bandwidth' / 'the amount of data sent per second'.

Example answers and how they were marked
Full marks2/2

The delay between a signal being sent and a response being received.

Why: Gives the delay (1) and the time between sending and receiving (1).

Some marks1/2

The time taken for data to travel.

Why: Gives the idea of time taken (1) but does not say between sending and receiving (1).

No marks0/2

The speed at which data is sent over the network.

Why: Describes speed, not latency; no creditworthy point.

3Short recall2 marksWireless Connections Swap Remove

Wireless networks have a limited range.

State two factors that can reduce the range of a wireless network.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Walls/obstacles between the device and the access point (1)
  • Interference from other electrical devices/other devices/other wireless networks (1)
  • Distance from the access point (1)
  • Using a higher frequency band (e.g. 5GHz) (1)
  • Low transmit power of the access point/device (1)

Allow thick walls/furniture for walls/obstacles

Do not accept using more bandwidth

Do not accept a weaker signal without a stated cause

Example answers and how they were marked
Full marks2/2

Walls can block the signal, and moving further from the access point reduces the range.

Why: Gives walls as an obstacle (1) and distance from the access point (1).

Some marks1/2

Interference from other devices.

Why: Gives one valid factor, interference from other devices (1), but no second factor.

No marks0/2

Using more bandwidth reduces the range.

Why: Bandwidth does not reduce range; this is a near-miss listed as Do not accept, so no mark.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 71
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 18 questions

5.3 Cybersecurity

Build a paper on this topic 36
Malware 18 questions Social Engineering 18 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.