Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 631 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 12 marks

Pick again
Print
1Short recall2 marksLow and High Level Languages Swap Remove

Device drivers allow hardware devices to work with a computer system.

Give two advantages of using a low-level programming language to write device drivers.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • It can control/manipulate the hardware (components/registers/memory locations) directly (1)
  • Each instruction maps to a single machine-code instruction, so the behaviour/timing can be controlled precisely (1)
  • The code can run very quickly / has a fast execution time (1)
  • The code uses less memory/RAM (1)
  • The code can be optimised for a particular processor/chipset (1)

Only award one mark where both 'controls the hardware' and 'accesses registers/memory locations' are given, as these are the same point.

Do not accept 'it is closer to the hardware' without saying that it controls or accesses the hardware directly.

Do not accept easier/faster to write/program/learn/understand/debug (these are advantages of high-level languages).

Do not accept faster/quicker without qualification.

Do not accept portable/machine independent.

Do not accept does not need to be translated/compiled (assembly language must be assembled).

Do not accept it is a low-level language / a repeat of the question.

Example answers and how they were marked
Full marks2/2

It can control the hardware directly and the code runs very quickly.

Why: Two creditworthy advantages: controls the hardware directly (1); fast execution (1).

Some marks1/2

It uses less memory than a high-level language.

Why: Creditworthy point: uses less memory/RAM (1). Only one advantage given.

No marks0/2

It is easier to understand and debug than a high-level language.

Why: These are advantages of high-level languages, not low-level ones; the mark scheme does not accept easier to understand or debug.

2Explain2 marksTranslators Swap Remove

A programmer writes a program in a high-level language. The program is translated by a compiler.

Explain why a compiler must translate the whole program before any of it can be executed.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The compiler produces object code/machine code for the whole program (1) so there is no complete executable until every line has been translated (1)
  • The compiler translates all the source code before producing the object code (1) so the program cannot start until translation has finished (1)
  • The compiler checks the whole program for errors during translation (1) so all of the source code must be read before an executable can be produced (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'in one go'/'all at once' for the translation point, but this does not earn the second mark unless it is linked to why the program cannot be executed until translation has finished.

A statement that the whole program is translated, with no linked reason about when the program can be executed, earns 1 mark only.

Do not accept 'a compiler is faster' or 'compiled code runs faster' on its own; this does not explain why translation must finish before execution.

Do not accept 'it translates and runs the program one line at a time', as this describes an interpreter.

Example answers and how they were marked
Full marks2/2

A compiler produces object code for the whole program, so there is no complete executable until every line has been translated.

Why: Object code for the whole program (1) linked to there being no complete executable until every line is translated (1).

Some marks1/2

A compiler translates the whole program in one go.

Why: Translation of the whole program only (1); no linked reason about when the program can be executed, so the second mark is not awarded.

No marks0/2

A compiler translates and runs the program one line at a time, so it stops when it finds an error.

Why: Confuses a compiler with an interpreter; nothing about translating the whole program before execution, so no creditworthy point.

3Explain2 marksTranslators Swap Remove

An interpreter translates a program one line at a time.

Explain why an interpreted program stops when it reaches a line that contains a syntax error.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • The interpreter translates and executes each line in turn (1) so it cannot continue past a line it cannot translate (1)
  • The interpreter finds the error when it reaches that line (1) so it stops and displays an error message before later lines are executed (1)
  • Each line is translated just before it is executed (1) so a syntax error in that line prevents that translation/execution from happening (1)
  • The interpreter does not translate the whole program first (1) so it only discovers the error when that line is reached during execution (1)

For both marks, the expansion must follow/associate with the statement.

Do not accept 'the program crashes' without saying that the interpreter cannot translate/execute the line.

Do not accept answers about how a compiler reports errors.

Example answers and how they were marked
Full marks2/2

The interpreter translates each line just before it executes it, so when it reaches the line with the syntax error it cannot translate that line and stops.

Why: Line-by-line translation (1) linked to being unable to translate the faulty line, so stopping (1).

Some marks1/2

The interpreter translates one line at a time, so it stops at the error.

Why: Line-by-line translation (1); 'stops at the error' repeats the outcome and does not explain why it cannot continue.

No marks0/2

It stops because the compiler reports all errors at the end.

Why: Describes a compiler, not an interpreter; no credit.

4Discuss6 marksLow and High Level Languages Swap Remove

A company is developing the firmware for a robotic vacuum cleaner. The firmware must read the distance sensors and control the motors. The vacuum cleaner has a small amount of memory.

Discuss the characteristics of a low-level programming language that make it suitable for writing the firmware.

Your answer should include:

  • control of the hardware
  • the efficiency of the code
  • the link between the language and the processor.
[6 marks]
Mark scheme

Indicative content

Control of the hardware

  • Low-level languages can read and write the contents of registers and memory addresses directly, so the firmware can take the values from the distance sensors without calling a library routine.
  • Assembly language instructions can read from and write to specific input/output ports on the vacuum cleaner's processor, so the motors can be switched on and off directly.
  • The programmer decides exactly which processor operations are carried out and in which order, which matters when the vacuum must reverse away from a step or an obstacle.
  • A low-level language puts nothing between the program and the hardware, so the programmer can control the hardware of the vacuum cleaner precisely.

Efficiency of the code

  • Assembly language code can be hand-optimised instruction by instruction, so the code that checks a sensor is as short as possible.
  • The programmer can choose which registers hold values that are used again and again, which cuts down the number of memory accesses the firmware needs.
  • A hand-written low-level program can be made compact, so it is more likely to fit in the small amount of memory the vacuum cleaner has.
  • Because each instruction does one defined job, the time taken to react to a sensor reading is predictable, which suits firmware that must not overrun.

Link between the language and the processor

  • Low-level languages are processor-specific, so the instructions used are those of the exact processor in the vacuum cleaner rather than general statements that need translating.
  • Each assembly language instruction maps to one machine code instruction, so the programmer knows precisely which processor operation will be carried out by each line of code.
  • An assembler turns each mnemonic into its machine code equivalent, so the machine code running on the vacuum cleaner's processor is exactly what the programmer wrote.
  • Code written for a different processor would have to be rewritten, which is acceptable here because the vacuum cleaner always uses the same processor.

Levels

  • Level 0 (0 marks): No rewardable content.
  • Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
  • Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
  • Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Within Level 1, award 1 mark for a single basic point and 2 marks for two or more independent basic points; Level 2 requires the points to be linked to the vacuum cleaner; Level 3 requires both control of the hardware and efficiency of the code, and a few concise, linked sentences can reach Level 3, so extra length is not required.

Accept registers, memory addresses, input/output ports, machine code and mnemonics as ways of describing access to the hardware, and accept 'a low-level language is faster' as a basic point on its own. Do not award 'binary is a low-level language' (machine code is written in binary, but binary is not a language), or characteristics of high-level languages such as being easy to read or portable, as characteristics of a low-level language.

Example answers and how they were marked
Full marks6/6

A low-level language can read and write to registers and to input/output ports directly, so the firmware can take the distance sensor readings and switch the motors without needing library routines. It can be hand-optimised instruction by instruction, so the code that checks a sensor is short and the time it takes is predictable, and a compact program is more likely to fit in the vacuum cleaner's small memory. The language is processor-specific and each assembly instruction maps to one machine code instruction, so the programmer knows exactly which operation the vacuum's processor will carry out, and the assembled machine code is exactly what they wrote.

Why: Covers all three bullets: direct control of registers and ports applied to the sensors and motors, hand-optimised compact code with predictable timing applied to the small memory, and the one-to-one link to the processor's own instruction set. Linked and applied throughout, so Level 3.

Some marks2/6

A low-level language can control the hardware directly. It can read the sensors and control the motors. It is also faster than a high-level language, so the vacuum responds quickly. This is useful because it has little memory.

Why: Three basic, independent points: direct control of the hardware applied to the sensors and motors, faster execution, and suitability for limited memory. They are asserted without development (no registers, ports or predictable timing) and the link between the language and the processor is missing, so Level 1, two or more basic points (2).

Some marks1/6

A low-level language is written in binary, so the computer can understand it directly. It is faster than a high-level language.

Why: 'Faster than a high-level language' is a creditworthy basic point (1). 'Written in binary' is not awarded, as binary itself is not a language and the do-not-award rule applies. Only one undeveloped point with no application to the vacuum cleaner, so Level 1, single basic point (1).

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.