Edexcel GCSE Computer Science (1CP2) Exam Questions

• A The next instruction (1)
• The only correct answer is A. The correct answer is the next instruction.
• B is not correct because data is fetched during the execute stage
• C is not correct because an instruction is decoded after it is fetched
• D is not correct because the program counter holds the address used to fetch the instruction

Award up to two marks for a linked description such as:

• A read/write head moves over the surface of the disk (1) to read/write data by detecting or changing the magnetic alignment of areas of the surface (1)
• The head magnetises areas of the disk surface in different directions (1) so each area represents a binary 1 or 0 (1)
• Data is stored on concentric circles called tracks (1) which are divided into sectors (1)

Allow one mark for tracks/concentric circles on their own.

For the second mark in the first two bullets, the response must refer to the magnetic alignment/charge being detected or changed, not just that the head reads/writes data.

Do not award a mark for 'it is magnetic' or 'it stores data in binary' with no description of how the data is stored.

Do not accept descriptions of optical storage (e.g. a laser, pits and lands) or solid state storage (e.g. electric charges in chips).

Award up to two marks for a linked description such as:

• Decodes each (fetched) instruction (1) to work out which operation is needed / which components should carry it out (1)
• Coordinates/directs the other components (1) by sending control signals along the control bus (1)
• Fetches the next instruction (1) by sending its address to main memory along the address bus (1)
• Sends a read/write control signal to main memory (1) so that the instruction or data is transferred during the fetch/execute stage (1)

Do not accept answers about synchronising the CPU or timing the cycles (that is the role of the clock).

Do not accept answers about carrying out arithmetic or logical operations (that is the ALU).

Do not accept answers about holding data or the results of instructions (that is registers/main memory).

Do not accept generic answers that only say the CU controls the CPU or processes instructions, with no linked development.

Only award one mark for a response that only repeats that the CU sends control signals; the second mark needs a linked outcome such as coordination, a memory read/write, or fetching an instruction.

Do not accept 'during the decode stage' as the development for the decoding point, as it restates the question.

Award up to two marks for a linked explanation such as:

• The battery lasts longer/needs charging less often (1) because embedded systems have low power consumption/use less power (1)
• It can be made small/light enough to wear on the wrist (1) because the processor, memory and input/output are combined on a single chip/microcontroller (1)
• It can carry out the step-counting function reliably (1) because it runs a single/dedicated program and cannot install other software (1)
• It has a low cost per unit (1) because it uses fewer/less powerful components than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

Award one mark for a valid point stated on its own, e.g. 'it is small/light enough to wear on the wrist' (1) or 'its battery lasts longer before it needs charging' (1).

Accept the same linked ideas in either order, e.g. 'it uses less power (1) so the battery lasts longer (1)'.

Do not accept 'it uses less power'/'low power' on its own as a complete explanation; it must be linked to the battery lasting longer/needing charging less often for the second mark.

Do not accept an expansion that simply restates the point, e.g. 'it is small (1) so it fits on the wrist' earns only the point mark; 'fits on the wrist' is not a linked cause and is not enough for the second mark.

Do not accept 'the battery is small' as the linked reason for low power consumption.

Do not accept responses that say other software/apps can be installed on an embedded system (0); embedded systems have a single/dedicated function and cannot install new software.