Edexcel GCSE Computer Science (1CP2) Exam Questions

• B RAM is faster to access than secondary storage (1)
• The only correct answer is B. The correct answer is RAM is faster to access than secondary storage.
• A is not correct because RAM is volatile
• C is not correct because RAM has a smaller capacity than secondary storage
• D is not correct because RAM is more expensive than secondary storage

Award up to two marks for a linked description such as:

• The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
• The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
• The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
• The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Award up to two marks for a linked description such as:

• Data is stored on (flash) memory chips/cells (1) as a pattern of electrical charges (1)
• A current/voltage forces electrons through a barrier (1) so that they are trapped (or not trapped) to hold/represent a value (1)
• Cells with a trapped charge and cells with no trapped charge (1) represent 1s and 0s/binary (1)
• The trapped charge remains when the power is turned off (1) so the data is not lost/it is non-volatile (1)

Do not accept responses that describe magnetic storage, e.g. magnetised platters, spinning disks or read/write heads, or optical storage, e.g. lasers, pits and lands.

Do not award a mark for 'it is solid state' or 'it has no moving parts' without a description of how the data is stored.

Do not award a mark for restating the stem, e.g. 'a laptop uses an SSD' or 'an SSD uses flash memory'.

'Data is stored as electrical charges' on its own, with no reference to memory chips/cells or to how the charge is held, earns a maximum of one mark (1).

A response that only describes electrons being trapped, with no link to how the value/data is represented, earns one mark (1). The second mark needs a link such as trapped and not trapped charge representing 1s and 0s, or the trapped charge being kept so the data is not lost.

Indicative content

Fetching and decoding an instruction

• The register that holds the address of the next instruction (the program counter) contains the address of the instruction to be fetched.
• This address is sent to main memory (RAM) and the instruction is copied from main memory into a register inside the CPU.
• The program counter is updated so that it holds the address of the next instruction in the program.
• The control unit decodes the instruction that has been fetched, working out which operation is required and which data or registers are needed.
• The control unit sends control signals to coordinate the other components as the instruction is carried out.
• The control unit decides what happens next, for example after a comparison it decides whether the next instruction is the following one or a jump.

The arithmetic logic unit (ALU) executes an instruction

• The control unit directs the arithmetic logic unit (ALU) to carry out the operation.
• The ALU performs arithmetic operations such as addition, subtraction, multiplication and division, for example adding two values in a program written by the class.
• The ALU performs logical operations such as comparing two values to see if they are equal or whether one is greater than the other.
• The result of the operation carried out by the ALU is passed back and stored in a register.
• The ALU operates on data that has been fetched from main memory; it does not fetch the instruction and it does not decide which instruction is next.

Registers

• Registers are small, very fast memory locations inside the CPU.
• They hold the data, addresses and results that the CPU is working on during the cycle.
• Registers are used in every stage of the cycle, not only when the ALU produces a result.
• Because registers are inside the CPU they can be read and written much faster than main memory during the cycle.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)
• A Level 3 answer must link the roles of all three components to the fetch, decode and execute stages. An answer that links only one component to a stage, with the other points listed separately, is Level 1 (1–2 marks); an answer that links two of the components to stages is Level 2 (3–4 marks). A point repeated under more than one heading is credited once only.
• Accept 'the program counter', 'the address register' or 'a register holding the address of the next instruction' as the register that holds the address of the next instruction. Do not accept 'the control unit performs the calculations', 'the ALU controls the timing of the CPU' / 'the ALU sends the clock signal' or 'registers are in main memory (RAM)'.