Edexcel GCSE Computer Science (1CP2) Exam Questions

• B RAM is faster to access than secondary storage (1)
• The only correct answer is B. The correct answer is RAM is faster to access than secondary storage.
• A is not correct because RAM is volatile
• C is not correct because RAM has a smaller capacity than secondary storage
• D is not correct because RAM is more expensive than secondary storage

Award one mark for any of the following up to a maximum of two marks:

• The program instructions and data are stored together in main memory/RAM (1)
• The same memory is used for both instructions and data (1)
• The instructions are fetched from main memory and executed by the CPU (1)
• The instructions are fetched and executed one at a time / in sequence (1)
• The program can be changed/replaced by loading new instructions into memory, without changing the hardware (1)

Do not accept the program is stored in secondary storage / on the hard disk.

Do not accept the program is stored in the CPU / in registers.

Award up to two marks for a linked explanation such as:

• The battery lasts longer/needs charging less often (1) because embedded systems have low power consumption/use less power (1)
• It can be made small/light enough to wear on the wrist (1) because the processor, memory and input/output are combined on a single chip/microcontroller (1)
• It can carry out the step-counting function reliably (1) because it runs a single/dedicated program and cannot install other software (1)
• It has a low cost per unit (1) because it uses fewer/less powerful components than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

Award one mark for a valid point stated on its own, e.g. 'it is small/light enough to wear on the wrist' (1) or 'its battery lasts longer before it needs charging' (1).

Accept the same linked ideas in either order, e.g. 'it uses less power (1) so the battery lasts longer (1)'.

Do not accept 'it uses less power'/'low power' on its own as a complete explanation; it must be linked to the battery lasting longer/needing charging less often for the second mark.

Do not accept an expansion that simply restates the point, e.g. 'it is small (1) so it fits on the wrist' earns only the point mark; 'fits on the wrist' is not a linked cause and is not enough for the second mark.

Do not accept 'the battery is small' as the linked reason for low power consumption.

Do not accept responses that say other software/apps can be installed on an embedded system (0); embedded systems have a single/dedicated function and cannot install new software.

Indicative content

Stored program concept

• Instructions and data are stored together in the same main memory (RAM).
• Instructions are fetched one at a time from memory and executed in sequence.
• The program can be changed by loading different instructions into RAM.
• The CPU can only execute instructions that are in main memory.

Role of RAM

• RAM holds the program instructions and the data being used.
• The address of the next instruction is held in the program counter (PC).
• The instruction is fetched from RAM using the address bus.
• The data bus carries the instruction from RAM to the CPU.
• RAM is volatile, so programs are lost when power is off.
• RAM is directly accessible by the CPU, unlike secondary storage.

Benefits

• The same hardware can run many different programs.
• Programs can be loaded and changed quickly.
• No need to rewire the computer for a new task.
• Makes general-purpose computers possible.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Indicative content

Fetching and decoding an instruction

• The register that holds the address of the next instruction (the program counter) contains the address of the instruction to be fetched.
• This address is sent to main memory (RAM) and the instruction is copied from main memory into a register inside the CPU.
• The program counter is updated so that it holds the address of the next instruction in the program.
• The control unit decodes the instruction that has been fetched, working out which operation is required and which data or registers are needed.
• The control unit sends control signals to coordinate the other components as the instruction is carried out.
• The control unit decides what happens next, for example after a comparison it decides whether the next instruction is the following one or a jump.

The arithmetic logic unit (ALU) executes an instruction

• The control unit directs the arithmetic logic unit (ALU) to carry out the operation.
• The ALU performs arithmetic operations such as addition, subtraction, multiplication and division, for example adding two values in a program written by the class.
• The ALU performs logical operations such as comparing two values to see if they are equal or whether one is greater than the other.
• The result of the operation carried out by the ALU is passed back and stored in a register.
• The ALU operates on data that has been fetched from main memory; it does not fetch the instruction and it does not decide which instruction is next.

Registers

• Registers are small, very fast memory locations inside the CPU.
• They hold the data, addresses and results that the CPU is working on during the cycle.
• Registers are used in every stage of the cycle, not only when the ALU produces a result.
• Because registers are inside the CPU they can be read and written much faster than main memory during the cycle.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)
• A Level 3 answer must link the roles of all three components to the fetch, decode and execute stages. An answer that links only one component to a stage, with the other points listed separately, is Level 1 (1–2 marks); an answer that links two of the components to stages is Level 2 (3–4 marks). A point repeated under more than one heading is credited once only.
• Accept 'the program counter', 'the address register' or 'a register holding the address of the next instruction' as the register that holds the address of the next instruction. Do not accept 'the control unit performs the calculations', 'the ALU controls the timing of the CPU' / 'the ALU sends the clock signal' or 'registers are in main memory (RAM)'.