Edexcel GCSE Computer Science (1CP2) Exam Questions

• B RAM is faster to access than secondary storage (1)
• The only correct answer is B. The correct answer is RAM is faster to access than secondary storage.
• A is not correct because RAM is volatile
• C is not correct because RAM has a smaller capacity than secondary storage
• D is not correct because RAM is more expensive than secondary storage

Award up to two marks for a linked description such as:

• Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
• The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
• The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
• Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Award up to two marks for a linked explanation such as:

• Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
• Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
• A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
• Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Indicative content

Machine independence

• A high-level language is machine independent, so the same source code can be run on different types of computer with few or no changes.
• The company can write the program once and sell it to users with different computers, without rewriting the code for each type of computer.
• Only one version of the program needs to be written and maintained, so development takes the company less time.

Processor specificity

• A low-level language is processor-specific, so a program written for one processor will not run on a different processor without being rewritten.
• Assembly language instructions depend on the instruction set of the particular processor, so the company would need a separate version of the program for each type of computer.
• Writing a separate low-level version for every type of computer would take the company much longer than writing one high-level program.
• Low-level code gives direct control of the hardware of one processor, so it is better suited to device drivers than to a program that must run on many different computers.

Translation

• High-level source code is translated for each type of computer by a compiler or an interpreter, so one version of the source code is enough for all the users.
• Assembly language is translated into machine code by an assembler, and the assembler produces machine code for one specific processor only.
• Machine code is already in a form that one particular processor can execute directly, but the same machine code will not run on a different processor.
• Each high-level statement translates into several machine code instructions, so the programmer does not need to know the instruction set of the processor.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Additional guidance

• Level 3 responses must cover both high-level machine independence and low-level processor specificity, with the effect on the company's decision.
• Do not award low-level language, assembly language or machine code as portable, or 'high-level languages are written in English/like English' as a reason for machine independence.