Edexcel GCSE Computer Science (1CP2) Exam Questions

• A They are lost (1)
• The only correct answer is A. The correct answer is They are lost
• B is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not stored permanently
• C is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not saved to secondary storage
• D is not correct because ROM is read-only memory that holds the start-up instructions, so the contents of RAM are not written to it

Award up to two marks for a linked description such as:

• The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
• The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
• The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
• The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Award up to two marks for a linked description such as:

• A read/write head moves over the surface of the disk (1) to read/write data by detecting or changing the magnetic alignment of areas of the surface (1)
• The head magnetises areas of the disk surface in different directions (1) so each area represents a binary 1 or 0 (1)
• Data is stored on concentric circles called tracks (1) which are divided into sectors (1)

Allow one mark for tracks/concentric circles on their own.

For the second mark in the first two bullets, the response must refer to the magnetic alignment/charge being detected or changed, not just that the head reads/writes data.

Do not award a mark for 'it is magnetic' or 'it stores data in binary' with no description of how the data is stored.

Do not accept descriptions of optical storage (e.g. a laser, pits and lands) or solid state storage (e.g. electric charges in chips).

Award up to two marks for a linked explanation such as:

• (The ECU) is more reliable/less likely to crash (1) because it only runs the one program/has a single purpose (1)
• (The ECU) cannot be affected by other software/viruses (1) because it cannot run other software/it can only run the program it was made for (1)
• (The ECU) is cheaper (1) because it has limited processing resources/less memory/simple components (1)
• (The ECU) uses less power (1) because it has limited processing resources/a simpler processor (1)
• (The ECU) is smaller (1) because it has fewer components/less memory than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

A suitable benefit stated on its own earns one mark.

Do not accept a description or a location given as the reason, e.g. 'because it is part of the car', 'because it is inside the engine', 'because it is embedded'.

Do not accept a description of an embedded system on its own as the benefit, e.g. 'it does one specific job' or 'it is part of the car'.

Do not accept 'it is faster'/'it has a more powerful processor' as embedded systems have limited processing resources.

Award up to two marks for a linked explanation such as:

• Decodes/interprets/translates the instruction (1) to work out what the instruction is/what operation is required (1)
• Sends control signals to the other components (1) so that the correct component carries out the instruction (1), e.g. the ALU/main memory
• Controls the fetch of the instruction from main memory (1) because the address of the next instruction is sent via the address bus (1)
• Controls the fetch of the next instruction from main memory (1) by sending a control signal/read signal to main memory (1)

For both marks, the expansion must follow/associate with the statement.

For the decode point, 'decodes the instruction' alone gains 1 mark; a second mark needs the purpose of decoding, i.e. working out what the instruction is/what operation is required.

Do not accept 'it controls the CPU' on its own, without naming a task in the cycle.

Do not accept 'it fetches the instruction from memory' on its own, as this describes the fetch step rather than the control unit's role; credit only if linked to controlling/signalling the fetch.

Do not accept carrying out arithmetic/logical operations, as these are carried out by the ALU, or holding the address of the next instruction, as this is the program counter.

Do not accept storing the instruction in a register (e.g. MAR/MDR), as this is not the role of the control unit.