Edexcel GCSE Computer Science (1CP2) Exam Questions

• A They are lost (1)
• The only correct answer is A. The correct answer is They are lost
• B is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not stored permanently
• C is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not saved to secondary storage
• D is not correct because ROM is read-only memory that holds the start-up instructions, so the contents of RAM are not written to it

• A Decodes instructions (1)
• The only correct answer is A. The correct answer is Decodes instructions.
• B is not correct because the arithmetic logic unit performs arithmetic operations
• C is not correct because main memory stores data and instructions
• D is not correct because registers temporarily store data being processed

Award up to two marks for a linked description such as:

• The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
• The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
• The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
• The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Award up to two marks for a linked description such as:

• Decodes each (fetched) instruction (1) to work out which operation is needed / which components should carry it out (1)
• Coordinates/directs the other components (1) by sending control signals along the control bus (1)
• Fetches the next instruction (1) by sending its address to main memory along the address bus (1)
• Sends a read/write control signal to main memory (1) so that the instruction or data is transferred during the fetch/execute stage (1)

Do not accept answers about synchronising the CPU or timing the cycles (that is the role of the clock).

Do not accept answers about carrying out arithmetic or logical operations (that is the ALU).

Do not accept answers about holding data or the results of instructions (that is registers/main memory).

Do not accept generic answers that only say the CU controls the CPU or processes instructions, with no linked development.

Only award one mark for a response that only repeats that the CU sends control signals; the second mark needs a linked outcome such as coordination, a memory read/write, or fetching an instruction.

Do not accept 'during the decode stage' as the development for the decoding point, as it restates the question.

Award up to two marks for a linked explanation such as:

• The battery lasts longer/needs charging less often (1) because embedded systems have low power consumption/use less power (1)
• It can be made small/light enough to wear on the wrist (1) because the processor, memory and input/output are combined on a single chip/microcontroller (1)
• It can carry out the step-counting function reliably (1) because it runs a single/dedicated program and cannot install other software (1)
• It has a low cost per unit (1) because it uses fewer/less powerful components than a general purpose computer (1)

For both marks, the expansion must follow/associate with the statement.

Award one mark for a valid point stated on its own, e.g. 'it is small/light enough to wear on the wrist' (1) or 'its battery lasts longer before it needs charging' (1).

Accept the same linked ideas in either order, e.g. 'it uses less power (1) so the battery lasts longer (1)'.

Do not accept 'it uses less power'/'low power' on its own as a complete explanation; it must be linked to the battery lasting longer/needing charging less often for the second mark.

Do not accept an expansion that simply restates the point, e.g. 'it is small (1) so it fits on the wrist' earns only the point mark; 'fits on the wrist' is not a linked cause and is not enough for the second mark.

Do not accept 'the battery is small' as the linked reason for low power consumption.

Do not accept responses that say other software/apps can be installed on an embedded system (0); embedded systems have a single/dedicated function and cannot install new software.