Edexcel GCSE Computer Science (1CP2) Exam Questions

• A They are lost (1)
• The only correct answer is A. The correct answer is They are lost
• B is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not stored permanently
• C is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not saved to secondary storage
• D is not correct because ROM is read-only memory that holds the start-up instructions, so the contents of RAM are not written to it

Award one mark for:

• Volatile (1)

Allow volatile memory / it is volatile.

Do not accept non-volatile, ROM, RAM or temporary/short term memory on their own, as these are not the term asked for.

Award up to two marks for a linked description such as:

• Decodes each (fetched) instruction (1) to work out which operation is needed / which components should carry it out (1)
• Coordinates/directs the other components (1) by sending control signals along the control bus (1)
• Fetches the next instruction (1) by sending its address to main memory along the address bus (1)
• Sends a read/write control signal to main memory (1) so that the instruction or data is transferred during the fetch/execute stage (1)

Do not accept answers about synchronising the CPU or timing the cycles (that is the role of the clock).

Do not accept answers about carrying out arithmetic or logical operations (that is the ALU).

Do not accept answers about holding data or the results of instructions (that is registers/main memory).

Do not accept generic answers that only say the CU controls the CPU or processes instructions, with no linked development.

Only award one mark for a response that only repeats that the CU sends control signals; the second mark needs a linked outcome such as coordination, a memory read/write, or fetching an instruction.

Do not accept 'during the decode stage' as the development for the decoding point, as it restates the question.

Award up to two marks for a linked description such as:

• The program's instructions (and the data it uses) are held in main memory/RAM (1) so the CPU fetches both the instructions and the data from that one memory (1)
• The CPU fetches the next instruction from main memory/RAM (1) using the address of the memory location that holds it (1)
• The CPU reads/fetches data from main memory/RAM (1) when an instruction needs it and writes the result back to main memory/RAM (1)
• The program's instructions are held in main memory/RAM while the program runs (1) and the CPU fetches them one at a time/one after another to be decoded and executed (1)

Allow 'memory' for main memory/RAM.

Allow 'gets' for fetches/reads.

For both marks, the development must say what the CPU does with the contents of main memory (fetches/reads/writes), not just that main memory is used.

Do not accept answers about the program being stored in secondary storage, such as on a hard drive, or about it being loaded from there.

Do not accept benefits such as the computer running faster or being easier for the user.

Do not accept naming CPU components (control unit, arithmetic logic unit, registers) or buses on their own, without saying what is stored or fetched.

Do not accept 'the computer stores data' on its own, without a link to the instructions of a program.

Award up to two marks for a linked explanation such as:

• Decodes/interprets/translates the instruction (1) to work out what the instruction is/what operation is required (1)
• Sends control signals to the other components (1) so that the correct component carries out the instruction (1), e.g. the ALU/main memory
• Controls the fetch of the instruction from main memory (1) because the address of the next instruction is sent via the address bus (1)
• Controls the fetch of the next instruction from main memory (1) by sending a control signal/read signal to main memory (1)

For both marks, the expansion must follow/associate with the statement.

For the decode point, 'decodes the instruction' alone gains 1 mark; a second mark needs the purpose of decoding, i.e. working out what the instruction is/what operation is required.

Do not accept 'it controls the CPU' on its own, without naming a task in the cycle.

Do not accept 'it fetches the instruction from memory' on its own, as this describes the fetch step rather than the control unit's role; credit only if linked to controlling/signalling the fetch.

Do not accept carrying out arithmetic/logical operations, as these are carried out by the ALU, or holding the address of the next instruction, as this is the program counter.

Do not accept storing the instruction in a register (e.g. MAR/MDR), as this is not the role of the control unit.