Edexcel GCSE Computer Science (1CP2) Exam Questions

• A They are lost (1)
• The only correct answer is A. The correct answer is They are lost
• B is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not stored permanently
• C is not correct because RAM is volatile and its contents are lost when the power is switched off, so they are not saved to secondary storage
• D is not correct because ROM is read-only memory that holds the start-up instructions, so the contents of RAM are not written to it

Award one mark for any of the following up to a maximum of two marks:

• Instructions/programs are held/stored in main memory (RAM) (1)
• The data the program uses is stored in the same memory as the instructions (1)
• Instructions are fetched (one at a time) from main memory by the CPU (1)
• Instructions (fetched from main memory) are decoded and executed (1)

Allow 'memory' for main memory/RAM.

Do not award two marks for a single statement that only says the program/instructions are stored in memory.

Do not accept answers that state the program is stored in secondary storage (such as a hard disk).

Award up to two marks for a linked explanation such as:

• Decodes/interprets/translates the instruction (1) to work out what the instruction is/what operation is required (1)
• Sends control signals to the other components (1) so that the correct component carries out the instruction (1), e.g. the ALU/main memory
• Controls the fetch of the instruction from main memory (1) because the address of the next instruction is sent via the address bus (1)
• Controls the fetch of the next instruction from main memory (1) by sending a control signal/read signal to main memory (1)

For both marks, the expansion must follow/associate with the statement.

For the decode point, 'decodes the instruction' alone gains 1 mark; a second mark needs the purpose of decoding, i.e. working out what the instruction is/what operation is required.

Do not accept 'it controls the CPU' on its own, without naming a task in the cycle.

Do not accept 'it fetches the instruction from memory' on its own, as this describes the fetch step rather than the control unit's role; credit only if linked to controlling/signalling the fetch.

Do not accept carrying out arithmetic/logical operations, as these are carried out by the ALU, or holding the address of the next instruction, as this is the program counter.

Do not accept storing the instruction in a register (e.g. MAR/MDR), as this is not the role of the control unit.