Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 604 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 7 marks

Pick again
Print
1Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

2Explain2 marksTopologies Swap Remove

A bus topology has a terminator at each end of its cable.

Explain why terminators are needed in a bus topology.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Terminators absorb the signal at the ends of the cable (1) so it is not reflected back along the bus (1)
  • Terminators prevent signals reflecting/bouncing back (1) so the reflected signal does not corrupt data on the cable (1)
  • Terminators absorb the signal (1) so it does not collide/interfere with data being sent by other devices (1)
  • Terminators stop the signal reflecting back down the cable (1) so data can be transmitted and received without errors (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'interfere'/'corrupt' only where the answer says the reflected signal mixes with/collides with data on the cable.

Do not accept 'to stop the signal' on its own, as stopping the signal is not the same as stopping it reflecting back along the cable.

Do not accept 'to terminate the cable/network', 'to end the cable' or 'to stop the cable breaking'.

Do not award responses that only repeat the stem, e.g. 'because there is a terminator at each end'.

Example answers and how they were marked
Full marks2/2

Terminators absorb the signal at each end of the cable (1) so that it does not reflect back along the bus (1).

Why: Linked point (1) and reason (1): absorbing the signal is linked to it not being reflected back along the bus.

Some marks1/2

Terminators absorb the signal at the ends of the cable.

Why: Awarded 1 mark for the point that the signal is absorbed, but no linked consequence is given.

No marks0/2

They terminate the network so the cable does not break.

Why: No credit: it does not say the signal is absorbed or that reflections are prevented, and the mark scheme rejects 'to terminate the network' and 'to stop the cable breaking'.

3Calculate3 marksAdding Binary Numbers Swap Remove

Binary patterns can represent numbers.

(a)

Complete the table to show the 8-bit result of the binary addition.

[2 marks]
1286432168421
11011011
11011100
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 1011 (1)
  • 0111 (1)

0 marks if the response is not 8-bit binary.

Ignore a carry shown beyond the eighth bit.

Example answers and how they were marked
Full marks2/2

1011 0111

Why: 219 + 220 = 439, which needs 9 bits; the 8 bits that are kept are both correct (2).

Some marks1/2

0000 0111

Why: Forgets to carry the 1s. The second nibble is correct (1); the first is not.

No marks0/2

1101 1111

Why: Never carries. Neither nibble is correct.

(b)

State the name of the error that occurs when this addition is carried out.

[1 mark]
Mark scheme

Award one mark for:

  • overflow (error) (1)
Example answers and how they were marked
Full marks1/1

Overflow

Why: The result needs more bits than are available (1).

No marks0/1

Underflow

Why: A near miss: the result is too big for 8 bits, not too small.

No marks0/1

A syntax error

Why: A syntax error is a mistake in a program's code, not in arithmetic.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.